DTF Station Warm Peel DTF Film Sheets

Check out this article on some great costume ideas using the DTF process.

Features:

1. High Ink Loading Layer: You can lay down more color / white to create rich colored decorated DTF prints.
   

2. Warm Peel: Peel off the film without a long wait after the first press.

3. Single Side Matte: Easily distinguish the print side.
4. Compatible with any DTF printer on the market
   

Instructions:

1. Print the image onto the matte side of the film in mirror mode. (CMYK>>White Ink)
2. Apply hot melt powder evenly and remove the excess powder. Use a Seismo Shaker unit - like the Seismo S20 - to apply powder with ease!
3. Hover with a heat press to bake the hot melt powder (340°F, 5min). Or use a curing oven (300-315 °F, 1min).
4. Transfer the image by heat press at 330°F for 15sec with medium pressure.
5. After the first press,
   Option 1: Wait for 4-6 seconds and remove the film gently
   Option 2: Rub the top surface with a cloth to remove some heat and peel off the film gently
6. Heat press again at 330°F 5-10sec with medium pressure to enhance softer hand feel.

WARNING


• Caution: When handling DTF Hot Melt Powder, do not ingest or inhale powder. Harmful if swallowed. Skin irritations may occur. Avoid contact with skin and eyes. If contact with eyes, rinse with large amounts of water. Wear protective clothing, gear, mask and gloves when handling powder. If allergic reaction persists or accidentally ingested, seek medical help immediately.
• For DTG printers, powder should NOT be applied on the platen. It needs to be applied AWAY from the printer. Application near the printer increases the risk of printer damage if the printer "breathes" in the adhesive powder into the intake fan by the electronics near the back of the machine. Damage to the printer for inappropriate use may not be covered under warranty.