Support
Machine type
Brand
Hotronix Craft Heat Press 9 x 12

Hotronix Craft Press pressure: using the knob, light to heavy settings and checking for even pressure

✓ Reviewed by Jason KimUpdated 2 min readFits: Craft Press 9 x 12 (CP912-120, EASY Brand)
Short answer

With the lift handle down, turn the over-the-center knob clockwise to increase pressure and counterclockwise to decrease it, allowing for the thickness of your garment. Too little pressure shows as transfers that won't stick or don't survive washing; too much shows as adhesive spreading, scorching or thin-looking ink. Test evenness with a slip of paper in each corner.

Pressure is the setting people most often get wrong on a small press. The Craft Press has Hotronix's over-the-center pressure knob, which pushes from the middle of the heat platen outward so the whole 9 x 12 in area gets the same force. There is no number readout, so you find your settings by testing.

Adjust the pressure

  1. Close the press

    Put the lift handle in the DOWN position. Hotronix has you adjust pressure this way.

  2. Turn the knob

    Turn the over-the-center knob clockwise to increase pressure and counterclockwise to decrease it.

  3. Allow for thickness

    Set pressure with the item you're pressing in place. A thick hoodie needs less knob than a thin tee for the same pressure.

  4. Test and note it

    Transfer makers specify light, medium or heavy. Hotronix says some trial and error is normal; once you have a setting that works, the press will repeat it press after press. Note the knob position for each material you use.

Hotronix's limited warranty does not cover structural damage caused by too much pressure. Turn the knob a little at a time and never force the handle to lock.

Too much or too little?

Sign Means Do this
Transfer won't stick Too little pressure Turn clockwise a little
Fails after washing Too little pressure Turn clockwise a little
Adhesive spreads past edges Too much pressure Turn counterclockwise
Scorch marks on fabric Too much pressure Turn counterclockwise
Ink looks thin Too much pressure Turn counterclockwise

These signs come from Hotronix's Perfect Pressure Guide. Also check temperature and time against your transfer's instructions before you change pressure a lot.

Keep the pressing area flat

Hotronix says the printing surface must be flat and free of raised items such as seams, zippers, buttons or buckles. If the item has them, a pressing pillow lets them sink down, or a print pad raises the print area above them.

Check that pressure is even

  1. Set your normal pressure

    Heat the press to your usual temperature.

  2. Place four slips of paper

    Put one slip of paper in each corner of the lower platen.

  3. Close and pull

    Close and lock the press, then try to pull each slip out.

  4. Compare

    They should all be equally hard to pull. If one slides out much more easily, the platen may not be pressing evenly. Text us a photo at (562) 609-4996.

A slightly loose-feeling heat platen is normal. Hotronix makes its platens float so they press evenly.

Common questions

Which way is more pressure?

Clockwise increases pressure. Counterclockwise decreases it. Adjust with the lift handle in the DOWN position.

My transfer says medium pressure. Where is that?

Hotronix says some trial and error is needed to find light, medium and heavy on this press. Once you find the setting that works, the press repeats it reliably.

The heat platen feels a little loose. Is that a problem?

No. Hotronix heat platens float on purpose so they press evenly from corner to corner.

How do I check pressure is even?

Close the press on four slips of paper, one in each corner, and try to pull them out. If one comes out much more easily, contact us.

Did this fix it?