Support
Machine type
Brand
Insta 907 Dual Station Shuttle Label Heat Press

Insta 907 Dual Station Shuttle Label Heat Press support

Covers: Insta 907 · 907S

The Insta 907 is an air-operated label press with two 6 x 6 in lower platens and one heated platen that swings between them, so you can load one station while the other presses. It runs on 120 V on its own 15 A circuit and needs 30 to 100 psi of air. Drain the regulator bowl monthly and keep the air off when the press isn't in use.

Insta 907 dual station shuttle label heat press

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Insta's video: how to use and operate the Insta 907 dual shuttle press

Embedded from the manufacturer's official channel.

About the Insta 907 Dual Station Shuttle Label Heat Press

The 907 is built for fast, repeat label and small logo work: tagless neck labels, chest logos and similar small transfers. The heated upper platen swings between two independent lower platens. While one station is pressing, you prepare the next garment on the other. Air does the pressing, and the press opens itself at the end of the timer.

Key specs

Item 907
Platens Two 6 x 6 in lower, one 6 x 6 in heated upper
Power (US) 120 V, 1000 W, 8.3 A, own 15 A circuit
Air 30 to 100 psi, never above 100
Controller 125 to 450°F, 1 s to 10 min, 5 presets, counter
Weight 61 lbs

Care at a glance

When What to do
Every day Keep the heat platen off the pads when idle. Turn the air off at the end of the day
As needed Wipe the coated platen with a soft cloth. Mineral spirits only when cold
Monthly Check the air regulator bowl for water and drain it

Where to put it

Set it on a secure, flat surface, with the base above the wall socket. If you need an extension cord, use an industrial one: 18/3 up to 25 ft, 16/3 up to 50 ft. Keep it away from liquids.