Support
Machine type
Brand
STS XpertJet 1682D (XPJ-1682D) 64 inch DTF Printer

STS XpertJet 1682D (XPJ-1682D) 64 inch DTF Printer support

Covers: XPJ-1682D

The STS XpertJet 1682D is a 64 inch direct-to-film printer built by Mutoh, with two staggered print heads, a touch panel, white ink circulation and an automatic color sensor for alignment. Mutoh designed it to stay powered on in Sleep Mode so it can circulate ink and clean the heads on a timer. The daily habits that matter most are agitating the white ink when the printer asks and printing a nozzle check before and after work.

STS XpertJet 1682D 64 inch DTF printer on its stand, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Manuals & downloads

Watch STS Inks' video: the XPJ-1682D 64 inch DTF printer

More videos

STS Inks: CR maintenance on the 1682 DTF printer

Embedded from the manufacturer's official channel.

About the STS XpertJet 1682D (XPJ-1682D) 64 inch DTF Printer

The XPJ-1682D takes media 500 to 1,625 mm wide (up to 64 inches) and prints up to 1,615 mm wide with two staggered print heads. Ink runs in eight slots: black, cyan, magenta, yellow, light cyan, light magenta and two white, fed from ink bags in high-capacity ink pack adapters, each with its own S/C card. It connects by Gigabit Ethernet, has a touch panel, three head heights (Low, Mid, High), a built-in color sensor for automatic alignment, and a 2,000 ml waste ink tank. You monitor and run maintenance from the panel or from the Mutoh Status Monitor (MSM).

Maintenance schedule at a glance

How often What to do
Before and after each day's printing Nozzle check, clean only if there are gaps
When the panel shows Shake W Cartridge (every 12 hours) Agitate the white ink bags
Every week Clean the cleaning wiper and around the capping unit
Every month Inside cleaning
About every 2 months Check the flushing box absorber and replace it when ink lumps rise above its frame
Every six months Replace the cleaning wiper
When the tank is half full or the panel says Full WasteInkTank Empty the waste ink tank
When not used for one to four weeks Head cleaning once a week, or Longstore if you can't

Where to put it

Mutoh's recommended printing environment is 22 to 30 °C (about 72 to 86 °F) and 40 to 60% humidity with no condensation, with temperature changing no more than 2 °C and humidity no more than 5% per hour. Keep the power on and use Sleep Mode when you're not printing. The computer should run Windows 11, 10 or 8.1 with at least an Intel Core i5 and 8 GB of memory, on a Gigabit Ethernet port with Category 6 or better cable.