Support
Machine type
Brand
DTF Station Prisma Dual Heat Press

DTF Station Prisma Dual Heat Press support

Covers: Prisma Dual (110 V and 220 V)

The Prisma Dual is a 16 x 20 in air-powered heat press with one heat platen that swings between two lower stations, so you load one shirt while the other presses. It runs off the air compressor that ships with it, uses a foot pedal to swing and a two-hand PRESS start, and has laser alignment, 10 saved presets and single, double or triple press cycles. Start here for setup, work modes, calibration and the manual.

DTF Station Prisma Dual heat press on its cabinet, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch DTF Station's video: Introducing the Prisma Dual heat press

More videos

Prisma Dual unboxing and setup
Prisma Dual laser alignment tutorial

Embedded from the manufacturer's official channel.

About the DTF Station Prisma Dual Heat Press

The Prisma Dual is a dual-station pneumatic press. A single 16 x 20 in heat platen swings left and right between two lower platens, so one garment is being pressed while you lay out the next. The swing is triggered with the foot pedal or the SWING control, and the press only comes down when both PRESS buttons are pushed at the same time, which keeps hands out of the way. Air comes from the compressor packed with the machine. RAMLOCK lower platens swap quickly between jobs, and a laser guide projects alignment lines onto the positioning pad.

Key specs

Heat platen 16 x 20 in
Max temperature 429°F
Power 110 V model: 1830 W, 16.64 A. 220 V model: 1830 W, 8.32 A
Air pressure 40 to 77 psi recommended, set on the touch screen
Work modes Manual, Semi-Auto and Auto, with single, double or triple press cycles
Presets Up to 10 saved profiles
Size and weight About 38.5 x 37.8 x 56.5 in, 456 lb

Before each shift

  • Turn on the press, then the compressor, and open the ball valve.
  • Push the blue manual slide valve toward the pressure gauge until pressure builds, and confirm the screen pressure sits between 40 and 77 psi.
  • Load the preset for the job and let the platen reach temperature.

Where to put it

Stand it on a flat floor and adjust and lock all four leveling feet so it doesn't rock. Plug it into a properly grounded outlet and don't run other high-power equipment, such as another heat press or a dryer, on the same circuit. If you have to use an extension cord, route it so nobody can trip on it or pull it. Never leave the press switched on and unattended.