Support
Machine type
Brand
Hotronix Auto Open Clam and Hover Heat Press

Hotronix Auto Open Clam and Hover Heat Press support

Covers: Auto Open Clam 16x20 · 16x16 · 11x15 · Hover Press 16x20

The Hotronix Auto Open Clam holds the platen down with an electromagnet during the countdown, then gas springs pop it open when the time is up. Temperature runs from 176 to 430°F, there are two timers for two-step jobs, and a 0 to 9 readout shows pressure. Before first use, remove the packaging bolt on top of the press.

Hotronix Auto Open Clam 16x20 heat press, open

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch Hotronix's video: Hotronix Auto Open Clam features and benefits

More videos

Hotronix Hover heat press with auto open
Unboxing the Hotronix Auto Open Clam
Hotronix Auto Open Clam: adjusting time and temperature

Embedded from the manufacturer's official channel.

About the Hotronix Auto Open Clam and Hover Heat Press

The Auto Open Clam is a clamshell press with automatic release. You lower and lock the handle, the countdown starts, and when it finishes the 12 V electromagnet lets go and the gas springs lift the heat platen. Hotronix covers the Hover press in the same manual, and all sizes use the same controls.

Key specs

Sizes 16 x 20, 16 x 16 and 11 x 15 in
Heater 1800 W (16 x 20 and 16 x 16), 1000 W (11 x 15)
Power 120 V needs a full 20 amp grounded circuit, 220 V a full 10 amp circuit
Temperature 176 to 430°F (79 to 220°C)
Timers Time #1 and Time #2 for two-hit jobs. For one hit, set both the same
Pressure readout 0 to 9 (1 to 3 light, 4 to 7 medium, 8 to 9 heavy)
Sleep Goes to sleep after two hours idle. Press any button to wake it

Where to put it

Use a sturdy stand at least 36 in long, 24 in wide and 29 in high. Don't share the circuit with other heat presses or high-draw equipment, and if you need an extension cord keep it short, heavy duty and no lighter than 12 gauge. A weak circuit gives erratic controls, wrong temperature readings, slow heat-up and a tripped breaker.