Support
Machine type
Brand
DTF Station Maxima and Proxima Dual Heat Presses

DTF Station Maxima and Proxima Dual Heat Presses support

Covers: Maxima Auto Dual · Maxima Semi-Auto Dual · Proxima Auto Dual (TQB-4050) · Proxima Semi-Auto Dual (TQ-4050) · Proxima Dual (TY4050)

The Maxima and Proxima dual presses have two lower platens and one heat head that moves between them, so you load one side while the other presses. The Auto and Semi-Auto models are air powered and need an external air compressor. Most setup calls are about the compressor connection and the air pressure, so start with the air compressor guide.

DTF Station Maxima Auto Dual heat press with two lower platens, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: How to use the Maxima Semi Auto heat press

Embedded from the manufacturer's official channel.

About the DTF Station Maxima and Proxima Dual Heat Presses

These are dual-station presses: one heat head serves two lower platens. In auto mode the head presses automatically once it reaches a station, then moves to the other side when the time is up. In manual mode you start each press with both press buttons (Proxima) or the start switch (Maxima). The Maxima Auto adds a laser alignment system and a safety light sensor. The Proxima Dual (TY4050) is the hand-operated version, with a press handle and pressure knob and no air supply.

Key specs

Maxima Auto / Semi-Auto Proxima Auto / Semi-Auto
Platen 16 x 20 in 15.75 x 19.69 in
Power 110 V. Auto: 3800 W, 15 A. Semi-Auto: 3500 W 110 V, 1.8 kW
Temperature 0 to 750°F range, 320°F recommended working temperature Set on the control panel
Timer 0 to 999 seconds Set on the control panel
Air About 60 psi at the press gauge, compressor delivering 85 to 100 psi Compressor of at least 1.5 kW with a 50 L tank and 0.7 MPa, hose 5 mm ID x 8 mm OD

Care at a glance

When What to do
Every day Drain water from the press air filter (push the drain valve at the bottom of the filter) and from your compressor tank
When results change Measure the gap between the heat plate and each lower platen on all four sides (see the uneven pressure guide)
After replacing a heat plate, thermocouple or controller Run the controller's self-tuning (see the temperature guide)

Where to put it

Give it a grounded outlet it doesn't share with other high-draw equipment, and remember the compressor may need its own outlet. Keep hands clear in auto mode: the head moves and presses on its own, and the Maxima has no front safety guard.