Support
Machine type
Brand
xTool P3

xTool P3 support

Covers: xTool P3

Everything for running an xTool P3: filling the coolant before first power-up, connecting to xTool Studio (the P3 does not work with XCS), daily lens checks, and xTool's safety rules. If the P3 will not connect, update xTool Studio first. Firmware 007 and later needs xTool Studio 1.58 or newer.

xTool P3 CO2 laser cutter, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch xTool's video: Introducing the xTool P3

More videos

How to unbox and first use the P3
xTool P3 automatic conveyor feeder unboxing

Embedded from the manufacturer's official channel.

About the xTool P3

The P3 is xTool's large-format enclosed CO2 laser cutter, with a 915 x 458 mm processing area, a water-cooled laser tube, a 5 MP close-view camera and a 16 MP overview camera. It weighs about 105 kg and runs on 100 to 240 V. It is a Class 1 laser product: the beam stays inside the enclosure, and interlocks stop the laser when the lid opens. It ships with the SafetyPro IF2 2.0 inline fan, which pairs with the P3 over Bluetooth.

Maintenance at a glance

How often What to do
Every day Check the focus lens, window lens and laser mirror. Clean them every 4 hours during long high-power runs.
After every job Remove scraps and residue from the work area. Built-up debris is a fire risk.
Regularly Check the coolant level, and the air purifier filters if you use one
After cleaning optics Check the optical path before cutting again

Where to put it

xTool rates the P3 for 5 to 30°C at 30 to 60% relative humidity, and says never to operate it below 0°C. Mix the coolant for the lowest yearly temperature in your area. Place it on a stable, flat, non-flammable surface, keep flammables away, and run the exhaust outdoors or through an air purifier.