Support
Machine type
Brand
DTF Station Prisma Swing Heat Press

DTF Station Prisma Swing Heat Press support

Covers: Prisma Swing 16 x 20 (GS-303)

The Prisma Swing is a manual 16 x 20 in swing-away press with a removable control box that plugs into the arm with aviation connectors. Pressure is set with the knob on top of the arm (clockwise for more), and temperature, time, °F or °C and the calibration offset are all set from the three buttons on the control box. It needs a dedicated, grounded 20 amp circuit at 120 V.

DTF Station Prisma Swing 16x20 swing-away heat press, closed

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

About the DTF Station Prisma Swing Heat Press

The Prisma Swing swings the heat platen away from the lower platen, so you can dress a shirt and place a transfer with no heat over your hands. The control box comes off the arm for service: it connects with a 5-pin and a 2-pin aviation plug, so a box can be swapped without opening the press. The lower platen uses the RAMLOCK quick change system, and the open base lets you slide a garment over the platen without stretching it.

Key specs

Platen 16 x 20 in, RAMLOCK quick change lower platens
Power 120 V, 1800 W, 16.4 A
Temperature Up to 430°F (221°C). About 20 minutes to reach 350°F
Timer 0 to 999 seconds, with a press counter
Opening Manual. No pressure readout

Care at a glance

When What to do
Every session Check that the power cord is still strapped to the 5-pin plug and clear of the heat platen
Heat cuts out Check both aviation plugs are fully seated
Transfers look off Check the platen temperature with a surface probe and adjust the offset if needed
As needed Replace a scorched PTFE sheet or worn lower pad

Where to put it

Use a sturdy table with room for the head to swing fully to the side. The support feet must be fitted, because without them the press can tip when the head swings away. Plug it into a grounded outlet on its own 20 amp circuit, with no other heat press or heavy appliance on the same circuit.