Support
Machine type
Brand
Insta 718, 728 and 828 Automatic Swing-Away Heat Presses

Insta 718, 728 and 828 Automatic Swing-Away Heat Presses support

Covers: Insta 718 · 728 · 828 (718S and 728S)

The Insta 718, 728 and 828 are air-operated automatic swing-away presses with 15 x 15, 15 x 20 and 20 x 25 in platens. You close them by holding both green start buttons until the platens touch, and they open on their own when the timer ends. They need compressed air between 30 and 100 psi and their own electrical circuit.

Insta 728 automatic swing-away heat press

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Insta's video: Meet the Insta 728 heat press

More videos

How to load a t-shirt onto the Insta 728
Interchangeable platens for Insta heat presses
Different voltage? Insta heat press machines

Embedded from the manufacturer's official channel.

About the Insta 718, 728 and 828 Automatic Swing-Away Heat Presses

The 718, 728 and 828 are Insta's air-operated swing-away presses. The heat platen swings off to the side while you load, then an air cylinder lifts the lower platen up to meet it. You start each press with two hands on the two green buttons, and the press releases by itself when the timer runs out. The red DISENGAGE button in the middle of the panel stops a cycle at any time.

Key specs

Model Platen Power (US)
718 15 x 15 in 120 V, 1500 W, separate 15 A circuit
728 15 x 20 in 120 V, 1750 W, separate 15 A circuit
828 20 x 25 in 230/240 V, 3300 W, separate 20 A circuit

All three take shop air at 30 to 100 psi through the regulator and gauge on the front of the base. The controller sets 125 to 450°F and 1 second to 10 minutes, holds five presets, and has a cycle counter, sleep mode and auto shut off.

Care at a glance

When What to do
Every day Leave the heat platen swung open when hot and idle. Turn the air off at the end of the day
As needed Wipe the coated heat platen with a soft cloth. Clean stubborn residue with mineral spirits only when cold
Monthly (heavy use) Grease the post and the heat platen pivot pin with high-temperature grease
When worn Replace the silicone pad

Where to put it

Insta wants an even, non-flammable surface that can hold at least 300 lbs, with the base of the press above the wall socket and nothing blocking the power switch. Keep liquids away, don't stretch the cord, and keep line voltage within 10% of the rating. Use the right extension cord gauge only if you must: 16/3 up to 25 ft, 14/3 up to 50 ft.