Support
Machine type
Brand
Graphtec CE8000 and CE7000 cutting plotters

Graphtec CE8000 and CE7000 cutting plotters support

Covers: CE8000-40 · CE8000-60 · CE8000-130 · CE7000-40 · CE7000-60 · CE7000-130

Everything for Graphtec's CE8000 roll-fed cutters and the CE7000 series they replaced: loading media, using the carrier sheet, keeping the media sensors clean, blade care and Graphtec's manuals and firmware. Graphtec's daily rules: never oil the plotter, and never use alcohol or solvents on the casing or the media sensors.

Graphtec CE8000-60 cutting plotter on its stand with media basket

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Manuals & downloads

Watch Graphtec's video: Getting familiar with the CE8000

More videos

CE8000: loading roll media
CE8000: blade preparation and mounting
CE8000 series Wi-Fi module installation

Embedded from the manufacturer's official channel.

About the Graphtec CE8000 and CE7000 cutting plotters

The CE8000 is Graphtec's roll-fed cutting plotter line, built as the CE8000-40 (desktop, 15 inch cutting width), CE8000-60 (24 inch) and CE8000-130 (50 inch). It replaced the CE7000 series, which Graphtec still supports as a legacy product. Both cut with a blade in a cutter plunger (blue cap for 0.9 mm blades, red for 1.5 mm), read registration marks for print-and-cut work, and detect the media with optical media sensors. The CE8000 uses a touch screen; the CE7000 uses keys and a small display.

When you raise the media set lever, the plotter asks what you loaded: ROLL-1 FRONT EDGE, ROLL-2 CURRENT POSITION or SHEET. Only SHEET detects the trailing edge, so pick it for cut sheets and the carrier sheet.

Daily care at a glance

Part What to do
Mechanism Never lubricate it
Casing Dry cloth, or a cloth with neutral detergent diluted in water. No thinner, benzene or alcohol.
Media sensors Cloth moistened with diluted neutral detergent. Never solvents or alcohol.
Cutting mat Dry cloth. Alcohol or diluted detergent only for stubborn stains.
Y rail Wipe gently with a dry cloth, leaving its lubricant on
Cutter plunger Clean paper dust and media powder off the blade and out of the plunger cap regularly
End of day Remove the tool, lower the set lever so the push rollers are raised, cover the plotter

Where to put it

Keep it out of direct sunlight and away from bright lamps, which can confuse the media sensors, and store media in the same room so it acclimates to the same temperature and humidity.