Support
Machine type
Brand
Lawson Zoom-AE DTG pretreatment machine

Lawson Zoom-AE DTG pretreatment machine support

Covers: Lawson Zoom-AE

The Zoom-AE is Lawson's all-electric DTG pretreat sprayer: no compressor, a pump that draws from up to two one-gallon jugs, and a speed knob that sets how much pretreat goes down. Lawson's rule is simple: flush it with distilled water and soak the spray tip at the end of every production day, run Magic Clean through it at least weekly, and keep a spare tip and filters on hand.

Lawson Zoom-AE pretreatment sprayer on its stand with the platen drawer open

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Lawson's video: Zoom-AE overview

More videos

Lawson: Zoom-AE daily maintenance

Embedded from the manufacturer's official channel.

About the Lawson Zoom-AE DTG pretreatment machine

The Zoom-AE is an all-electric industrial pretreat sprayer made by Lawson in St. Louis. You load the shirt on the pull-out drawer platen, press Start, and the spray head travels forward, reverses and sprays on the way back. It needs a standard 120V outlet (5 amps) and no air compressor.

What matters for upkeep

  • Two one-gallon jug spots, each with its own on/off fluid valve. Most shops run one gallon of pretreat and one of distilled water for cleaning. Only open the valve for a jug that has liquid in it: with both open and one jug empty, the pump won't prime.
  • How much pretreat lands on the shirt depends on three things: the head's travel speed (the speed knob), the spray tip, and the tip's distance from the fabric. Weigh shirts to set the speed.
  • The spray tip sits in Lawson's quick exchange cap, so it pops out for an overnight soak and goes back in the right position either way round.
  • Spray length is set by moving the front and rear limit switch brackets. Big speed changes can shift where the spray starts and stops.
  • Two buckets at the back collect overspray. The standard platen is 16 x 20 inches, and Lawson offers youth and child platens.

Lawson's maintenance schedule at a glance

How often What to do
End of every production day Purge distilled water through for 10 to 15 seconds, take the tip out and soak it in distilled water, brush the tip, wash the inside with a sponge and hot soapy water
Weekly (every few days in production shops) Purge Lawson's Magic Clean for 8 to 15 seconds, then distilled water. Spray the drawer slides with silicone or WD-40. Clean and oil the head rail and extrusion.
Keep on hand At least one spare spray tip, about four slip-on tube filters, and in production a spare fluid valve and pump

Where to put it

Use only distilled water in the fluid system: Lawson warns tap water minerals damage the tip and valves. Hot rooms make clogs more likely, because pretreat is essentially glue in salt water. Lawson built the Zoom-AE for commercial use and bases its warranty on one 8-hour shift, five days a week.