Support
Machine type
Brand
STS XPD-724 DTF Printer (Mutoh)

STS XPD-724 DTF Printer (Mutoh) support

Covers: XPD-724

The STS XPD-724 is a 24 inch direct-to-film printer from STS Inks, built on a Mutoh chassis with internal white ink circulation and run from the Mutoh Status Monitor (MSM). STS designed it to stay powered on, so the circulation can run overnight. Most problems come from white ink that was not shaken, a print head that touched the film, or a printer that sat idle without Long Store. The guides below follow STS's own manual and best practices.

STS XPD-724 direct-to-film printer on its stand, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Manuals & downloads

Watch STS Inks' video: shaking the whites before waking the printer

More videos

STS Inks: wet capping the 628 and 724 after a head strike
STS Inks: 628 and 724 rail maintenance and grease
STS Inks: 628 and 724 heat platen maintenance
STS Inks: clearing a clogged 628 or 724 waste tank

Embedded from the manufacturer's official channel.

About the STS XPD-724 DTF Printer (Mutoh)

The XPD-724 is STS Inks' compact 24 inch DTF printer. It takes roll film up to 630 mm (about 24.8 in) wide, prints up to 620 mm wide, and connects to your computer by Ethernet only. You control it through the printer driver and the Mutoh Status Monitor (MSM), where you run nozzle checks, cleanings, Long Store and Initial Charge. It uses XPD ink only, in a CMYK plus two white and two cleaning slot layout. It has a built-in cutter, a platen heater you can set from 30 to 45 °C, and a 1,500 ml waste ink tank that you drain by hand.

Maintenance schedule at a glance

How often What to do
Every day, before waking the printer Take out and shake both white cartridges, wipe free ink off the cartridge ends, check the platen and media guards are clean, then print a nozzle check
Every day, after production Clean the print head guards and the black plastic ramps at each end of the head
Every second day Clean the capping station seal and the spit pad
Every week Clean the cleaning wiper and its drain path, and around the print head, with a dry cleaning stick
Every month Inside cleaning: brush the pressure arms, wipe the platen, media guide and grid roller with a well wrung damp cloth
About every 2 months Check the flushing box absorber and replace it when ink lumps rise above its frame
Every 2 to 3 months, and before any long idle period Run Long Store from MSM to flush the ink lines

Where to put it

Keep it out of direct sunlight, in a dust-free spot with minimal static. The STS manual specifies 68 to 75 °F and 45 to 55% humidity with no condensation, and no swings of more than 4 °F or 5% humidity per hour. Leave it powered on, plugged into a surge protector, and STS recommends a 500VA UPS against power cuts. Always print with the front cover down.