Support
Machine type
Brand
DTF Station Vega S17

DTF Station Vega S17 support

Covers: Vega S17

The Vega S17 is one machine that prints, cuts, powders, cures and stacks DTF transfers from a 17 inch film roll. Its print section sits on top of its finishing section, and one touchscreen runs both. The most important rule: leave it powered on. It cleans and circulates its own ink on a schedule, and it can only do that when it is on, error free, and has ink.

DTF Station Vega S17 all-in-one DTF machine, three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Watch DTF Station's video: Vega S17 all-in-one DTF production line overview

Embedded from the manufacturer's official channel.

About the DTF Station Vega S17

The Vega S17 takes an art file in and gives you cut, powdered, cured sheets that are ready to press. It runs from a 17 inch roll of transfer film, prints up to 15.5 by about 19 inches per sheet, and uses Color Prime Chroma water-based pigment ink (CMYK plus white) in sealed, chipped cartridges. Adhesive powder comes from a sealed cartridge, so you never handle loose powder in normal use.

It has two sections in one machine: the print section on top and the finishing section underneath, which powders, cures, cuts and stacks. When we need to tell you where to look, we'll use those two names.

Maintenance at a glance

How often What to do
Automatic The machine circulates white ink every hour, cleans the white channels every 3 hours, cleans all channels every 12 hours, and wet-caps the white heads after 6 hours idle. Only if it is on and has no error.
Every day Shake the white cartridges when prompted, print a nozzle check before you print
Every week Clean the maintenance unit, left ink sump and media guide (about 10 min), clean the nozzle cover (about 15 min), brush the heater bed in the finishing section
Every month Clean and re-grease the guide rods (about 30 min), wipe the powder level sensor
Every 3, 6 and 9 months Replace the HEPA and carbon filter, the medium filter and the de-mist filter, in that order of frequency. Heavier use means sooner.
When the panel says so Empty the waste ink bottle, then reset the counter

Where to put it

Keep the room between 59 and 77°F with 45 to 70% humidity. Below 45% humidity, nozzles drop out more often. Leave about 39 inches of clear space around the machine and about 4 inches above it. The two sections each have their own power cord: confirm circuit requirements with us before installation. The finishing section has three filter stages that capture fumes and fine adhesive powder, so no external ventilation is required.