Support
Machine type
Brand
Pearl Elite and Pearl PTM DTG pretreatment machines

Pearl Elite and Pearl PTM DTG pretreatment machines support

Covers: Pearl Elite · Pearl PTM

The Pearl Elite (enclosed cabinet with a drawer) and the Pearl PTM (open frame) are touchscreen DTG pretreatment machines built by Thought Tech. Both pull pretreat straight from your jug, spray a 16 x 20 to 21 inch area and save up to 20 settings. Pearl requires a distilled water flush after every day of use, and the Elite manual warns that pretreat should never sit in the machine for more than 30 minutes.

Pearl Elite enclosed DTG pretreatment machine with touchscreen and front drawer

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Pearl's video: Pearl PTM and Elite overview

More videos

Pearl: cleaning and purging the spray nozzle
Pearl: adjusting the shirt platen height on the Elite

Embedded from the manufacturer's official channel.

About the Pearl Elite and Pearl PTM DTG pretreatment machines

Pearl pretreaters are designed and built in the US by Thought Tech. Two models share the same touchscreen software, nozzle and spray system:

  • Pearl Elite: a fully enclosed cabinet. The platen sits in a pull-out drawer, a front window gives you access to the nozzle, side windows open for cleaning, and an exhaust fan with a passive filter keeps mist inside. About 19 x 19 x 26 inches.
  • Pearl PTM: an open frame where the nozzle cart runs on an aluminum rail over the platen. It adds a Speed Mode for fast loading and an optional Flexlock platen attachment for a 10.5 x 11 inch pocket or crest area. About 33 x 23 x 15 inches.

What matters for upkeep

  • There is no tank. A 1/4 inch hose pushes into the quick-connect inlet and the pump draws straight from your jug of pretreat or distilled water.
  • The spray density setting runs from 20 to 100. Pearl rates the full range at about 12 to 60 ml over the full spray area. Spray length is set on the same screen.
  • The nozzle is a TeeJet TP9501EVS. It sits in the twist-off nozzle cap with a rubber seat, and on the Elite a check valve that stops drips after each pass.
  • Light and dark pretreat each have their own level meter and cost counter, so use the Maintenance menu prime buttons when you switch, or the counts drift.
  • The machine will not let you power down from the screen until the lines have been flushed with water.

Pearl's maintenance schedule at a glance

When What to do
Any pause over 30 minutes (Elite) Don't let pretreat sit in the machine. Flush it out.
End of every working day Prime the pretreat out, flush with distilled water until the lines run clear, store the nozzle in distilled water, then power down from the Maintenance menu
After every use (Elite) or every 10 cycles (PTM) Wipe pretreat off the inside with shop towels, then all-purpose cleaner
As needed (PTM) Lubricate the rail with a silicone spray, and tighten the drive belt if the cart sputters

Where to put it

Pearl runs on 110V 60Hz or 220V 50Hz and draws up to 150W. Keep it indoors, out of the weather, and on the Elite keep the exhaust vent clear. Never use solvents, gasoline or acids in it.