Support
Machine type
Brand
DTF Station Aries 124 UV DTF printer

DTF Station Aries 124 UV DTF printer support

Covers: Aries 124

The Aries 124 is DTF Station's 24 inch UV DTF printer, with four Epson i1600 U1 heads, a water chiller for its UV lamps and an air compressor. It prints and laminates A and B film in one pass. Clean it only with UV DTF cleaning solution, fill the chiller only with distilled water, and start each day with two head cleanings and a nozzle check.

DTF Station Aries 124 UV DTF printer, three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: Aries 124 assembly, including the chiller and compressor

More videos

Aries 124 full maintenance guide
Aries 124 how to reduce varnish
Introducing the Aries 124 UV DTF printer
What is new on the updated Aries 124

Embedded from the manufacturer's official channel.

About the DTF Station Aries 124 UV DTF printer

The Aries 124 prints up to 23.6 inches wide on 23.62 inch A film and laminates it to B film in the same pass. It runs 10 channels: CMYK, light cyan, light magenta, light black, light light black, white and varnish. Four Epson i1600 U1 print heads do the printing. It's driven by DTF Station Pilot software with NeoStampa as the RIP.

Compared with the compact Aries 213, it adds a water chiller (800 ml of distilled water only), an air compressor with a pressure gauge, cabinets for the chiller and air filtration unit, and a pneumatic film release. The printer, the chiller and the air filtration unit each have their own power draw: confirm circuit requirements with us before installation. Assembly takes at least four people to lift.

Maintenance at a glance

How often What to do
Every morning Wait for Idle, turn on white ink circulation (dial to 25) and the air compressor, check the air pressure gauge, run two head cleanings and a nozzle check
End of every day Clean under the carriage, both UV lamps, the wiper and all four caps with UV DTF cleaning solution, leave a little solution on the caps, reset the carriage to home
Every week Clean the encoder strip and the print bed with UV DTF cleaning solution, cut and remove old film
As needed Grease the rail, replace the air filtration filters (arrows pointing down), drain and refill the chiller with distilled water