Support
Machine type
Brand
Miro DTF Powder Shakers: Miro 13 Max, 16, 24 and 36

Miro DTF Powder Shakers: Miro 13 Max, 16, 24 and 36 support

Covers: Miro 13 · Miro 13 Max · Miro 16 · Miro 24 · Miro 36 · Miro 36 Pro

Support for DTF Station's Miro powder shakers, which powder, cure and purify in one inline unit with heat from underneath the film. Most problems come down to three things: glycerin and filter upkeep (smoke, drips), the film sensor and take-up reel, and heating plates that read differently from the real temperature. Each has a guide below, plus DTF Station's manuals.

DTF Station Miro 24 DTF powder shaker and dryer with take-up reel

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: Miro 24 daily, weekly and as-needed maintenance

Embedded from the manufacturer's official channel.

About the Miro DTF Powder Shakers: Miro 13 Max, 16, 24 and 36

Miro shakers sit in front of the printer. Film passes over a heated preheating plate, through a powder trough where a paddle shakes off the excess, then over a heated main plate that cures the powder from underneath while a built-in purifier pulls the fumes through a filter. A media wheel and film sensor tell the take-up reel when to pull.

Model Max film width Power
Miro 13 Max 13.78 in (35 cm) 110 V, 10.6 A
Miro 16 17.7 in (45 cm) 110 V, 12.7 A
Miro 24 23.62 in (60 cm) 110 V, 15.5 A
Miro 36 Pro 36 in (90 cm) Two cords, each on its own 20 A circuit (110 V model)

Maintenance at a glance

How often What to do
End of every day Run the purifier at least 5 minutes with the chamber open to cool, then wipe the chamber, glycerin buildup and sensor with 90% or stronger isopropyl alcohol. Empty the powder tray into a sealed container.
Weekly Clean the glycerin catch trays on both sides
Monthly Replace the purifier filters, air vent filter and fabric top cover (Miro 36 Pro: rotate filters daily, replace when blackened)
About every hour of printing Check and top up the powder

Where to put it

Give each Miro its own circuit. DTF Station warns against running other high-power equipment on the same circuit, and the Miro 36 Pro's two cords must go into two separate circuits, never a power strip or extension cord. Built-in purifiers don't replace room ventilation, so keep a window or fan going.