Support
Machine type
Brand
Summa F Series flatbed cutters (F1612, F1432, F1832, F3220, F3232)

Summa F Series flatbed cutters (F1612, F1432, F1832, F3220, F3232) support

Covers: F1612 · F1432 · F1832 · F3220 · F3232

Summa F Series tables are flatbed cutters controlled entirely from Axis Control on the PC, with up to three tool modules on the carriage. Start Axis Control before you power the table, always click Change Tool before touching a knife or module, and move the conveyor about 1 m by hand each morning. Heavier service is done by Summa-trained technicians when Axis Control asks for it.

Summa F1612 flatbed cutting table seen from above, with conveyor belt and carriage

Setup & first print

Daily & weekly maintenance

Troubleshooting

Guides are on the way. In the meantime, text our tech team a photo of the problem.

Error messages

Techniques & settings

Manuals & downloads

Watch Summa's video: F Series module and tool change

More videos

How to mount a tangential module on an F Series
How to mount a drag module on an F Series
F1612 continuous sheet feed

Embedded from the manufacturer's official channel.

About the Summa F Series flatbed cutters (F1612, F1432, F1832, F3220, F3232)

The Summa F Series are industrial flatbed finishing tables: a vacuum table with a conveyor belt, a carriage that holds up to three removable tool modules, and a fixed central unit with a positioning laser and a camera for reading registration marks. A drag module comes standard; tangential, rotary and router modules are options. Tangential tools carry a barcode so the table recognizes them. There is no control panel on the machine. Everything runs from Summa's Axis Control software on the connected PC, with an optional remote.

Model Working area (AA listing)
F1612 63 x 47 in
F1432 54 x 126 in
F1832 72 x 126 in
F3220 128 x 82 in
F3232 128 x 126 in

The F1432, F1832 and F3232 support Tandem mode, which splits the table into front and rear areas so you can load one side while the other cuts.

Maintenance at a glance

How often What to do
Daily, before start-up Move the conveyor forward by hand about 1 m
Daily Clear dust and cut residue; test the light barrier and emergency stops
Weekly Full visual inspection of the table, modules and tools
As cut quality drops Clean the nose piece or gliding disk, the conveyor, the ADC lens; replace worn knives
Monthly (POT tables) Check the oil level and top up below half
When Axis Control asks Service maintenance by a Summa-trained technician

Where to put it

Summa specifies 15 to 35°C (59 to 95°F) and 35 to 75% relative humidity, non-condensing, and asks you to let media acclimatize first. Summa's site preparation document for your model covers floor space and power. The F Series has no power plug: an electrician wires the cable directly into the machine on site. Connect it straight to the PC with USB 2.0 or better, no hub, on a cable no longer than about 3 m.