Support
Machine type
Brand
DTF Station Aries 213 and Aries 113 UV DTF printers

DTF Station Aries 213 and Aries 113 UV DTF printers support

Covers: Aries 213 · Aries 113

The Aries 213 and Aries 113 are compact UV DTF printers that print on A film and laminate it to B film in one pass, making peel-and-stick transfers for hard surfaces. No powder, oven or heat press. The rule that matters most: clean them only with UV DTF cleaning solution. Water-based DTF cleaning solution reacts with UV ink and causes clogs.

DTF Station Aries 213 UV DTF printer, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: Aries 213 assembly

More videos

Aries 213 ink fill, ink charge and nozzle check
Aries 213 loading media and setting tension
Aries 213 end of day maintenance
Introducing the Aries 113 UV DTF printer

Embedded from the manufacturer's official channel.

About the DTF Station Aries 213 and Aries 113 UV DTF printers

The Aries 213 prints UV-curable ink (CMYK, white and varnish) onto A film, cures it with UV lamps, and laminates it to B film through a heated roller. You cut the result and apply it cold with a squeegee to mugs, tumblers, hard hats, signs and other hard surfaces. It uses an Epson i3200 U1 print head, prints up to 11.8 inches wide on the 11.81 inch film, and is driven by DTF Station Pilot software with NeoStampa as the RIP. It has a built-in white ink circulation system, a head-strike sensor, and an air filtration unit.

The Aries 113 is the earlier compact model. It uses the same 11.81 inch A and B film and the same ink, but its print head and some procedures differ. If you own a 113, text us before you follow a 213-specific step.

Maintenance at a glance (Aries 213)

How often What to do
Before every print run Nozzle check. Also after any pause of 20 minutes or more.
End of every day Clean around the print head, capping station and wiper with UV DTF cleaning solution, cap the head, switch off heating, vacuum, light, take-up motors and air filtration
Every week Clean the encoder strip, print bed and film sensor with isopropyl alcohol, wipe the heating roller with a dry cloth only, empty the waste ink bottle, clean the air filtration hose
As needed Grease the rail, clean the two UV lamps, deep-clean the capping station, replace the air filtration filters (arrows pointing up)