Support
Machine type
Brand
Viper XPT-1000 pretreatment machine

Viper XPT-1000 pretreatment machine support

Covers: Viper XPT-1000

The Viper XPT-1000 is a single-nozzle, open-air pretreatment sprayer made by i-Group Technologies. It has three supply lines (pretreat, water and cleaning solution) with a push button for each, so the daily flush takes under a minute. Flush it at the end of every day and run the bi-weekly line clean, and most spray problems never start.

Viper XPT-1000 pretreatment machine spray unit with yellow platen

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch Viper's video: XPT-1000 setup

More videos

Viper: removing the XPT-1000 spray unit from the box
Viper: mounting the XPT-1000 spray unit to the base

Embedded from the manufacturer's official channel.

About the Viper XPT-1000 pretreatment machine

The XPT-1000 is i-Group Technologies' entry pretreatment machine. A single spray head travels on an arm over an open-air spray base, and two knobs on the front control everything: SPEED sets how much pretreat goes down (slower travel lays down more) and LENGTH sets how far it sprays.

Key specs for upkeep

  • Spray area up to 20 x 24 inches. Spray length adjustable from 2 to 24 inches.
  • Lays down roughly 5 to 60 grams over a 14 x 14 inch area, depending on the speed setting and the spray head height (adjustable from 6 to 11 inches). Use the laydown chart on top of the spray unit, and weigh test shirts.
  • Three supply tubes with filters: pretreat (red button), water (blue button) and cleaning solution (green button).
  • Runs from a standard 110V outlet through the included 24V power supply. Press the red E-stop and unplug before any service.

Viper's maintenance schedule at a glance

How often What to do Time
Every working day Purge with cleaning solution, then water, and wipe off any pretreat About 1 min
Every two weeks Run cleaning solution and then water through the pretreat line, and check the filters on all three tubes About 5 min
As needed Clean the spray tip, spray head solenoid or fluid solenoids if the pattern goes bad 10 to 20 min

Where to put it

The XPT-1000 fits on a standard 24-inch-deep table. Set the spray base on a level table, and lift it with two people from the bottom, never by the spray bar.