Support
Machine type
Brand
DTF Station Prestige R2 Pro

DTF Station Prestige R2 Pro support

Covers: Prestige R2 Pro

Everything for keeping a DTF Station Prestige R2 Pro printing: the end-of-day and weekly routine, fixes for clogs, weak white and error codes, NeoStampa and Pilot setup, and DTF Station's own manual and setup guide. The R2 Pro runs two Epson i1600 heads, one for CMYK and one for white. If you own the original Prestige R2 (XP600 heads), use the R2 page instead: many parts and repairs are shared, but not all.

DTF Station Prestige R2 Pro DTF printer, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: introducing the Prestige R2 Pro

More videos

Prestige R2 Pro software installation
Prestige R2 operation
Prestige R2 end-of-day maintenance
Prestige R2 weekly maintenance

Embedded from the manufacturer's official channel.

About the DTF Station Prestige R2 Pro

The Prestige R2 Pro is DTF Station's 13-inch (33 cm) desktop DTF printer. It has two Epson i1600 print heads: the left head (H1) prints CMYK and the right head (H2) prints white. It has a built-in sheet cutter, a white ink management system that keeps white ink stirred and circulating, a head-strike sensor, a film sensor, and a passive cleaning cycle that runs every 4 hours while the printer sits on its capping station. It runs on standard 110V power and weighs about 130 lb, so lift it with two people.

Current units ship with NeoStampa (the RIP, licensed by a USB dongle) and DTF Station Pilot (the control software). Early units shipped with Hosonsoft (PrintExp) and DigiRIP instead. The printer connects to a Windows PC by Ethernet cable.

Maintenance schedule at a glance

When What to do
Start of every day Shake the white ink bottle. Print a nozzle check before the first job and print only when at least 90% of the nozzles are firing. Clean or Fill Ink only if the check calls for it.
End of every day Clean around the print head, the capping station, the wiper blade and the cap tops with cleaning solution. Wet the cap sponges, dock the head and run one cleaning. Leave the printer on with the heater and LED off.
Every week Empty the waste ink bottle. Clean the encoder strip and air suction vents with 90% or stronger isopropyl alcohol. Wipe the pinch rollers with a dry lint-free cloth (no alcohol).
As needed Grease the carriage rail if it squeaks (heat-resistant paste grease, never a spray). Rinse the ink containers only with a technician's guidance.
About once a year Replace dampers and inlet filters. Cap tops, wiper blade and print heads typically last 1 to 2 years.

Where to put it

DTF Station's technicians aim for a room at 70 to 75°F and 35 to 45% humidity. Keep fans, air conditioning and heater vents from blowing on the printer, and keep it out of direct sun. Hot, dry air dries out the white head first, and a cold room hurts cyan and magenta. Put it on a sturdy, level table, keep the waste ink bottle on the floor or anywhere lower than the printer, and run the Ethernet cable straight to the computer with no router or switch in between.