Support
Machine type
Brand
Vastex D-100 and D-1000 Entry Level Infrared Conveyor Dryers

Vastex D-100 and D-1000 Entry Level Infrared Conveyor Dryers support

Covers: D-100 · D-1000 (120 V and 240 V)

The Vastex D-100 and D-1000 are tabletop infrared conveyor dryers with one heater, a Teflon-coated belt, a dial heat control from LO to HI and a variable belt speed. The D-100 has an 18 in belt and plugs into a dedicated 15 amp circuit; the D-1000 has a 26 in belt and needs a dedicated 20 amp circuit. Start here for setup, cure settings, belt tracking and the manual.

Vastex D-100 infrared conveyor dryer, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Vastex's video: Curing plastisol ink with the Vastex D-100

More videos

Curing discharge ink on a Vastex D-100

Embedded from the manufacturer's official channel.

About the Vastex D-100 and D-1000 Entry Level Infrared Conveyor Dryers

Both models have an 18 in long chamber with a medium-wave infrared heater whose height and tilt you set with a knob on each side. A 90 V DC gear motor drives the belt through a #25 chain. The belt is Teflon-coated fiberglass, joined with an alligator lace and a steel pin. The D-100 ships partly assembled; the D-1000 conveyor comes in two halves that bolt together and can take an optional 10 in extension.

Key specs

D-100 D-1000
Belt width 18 in 26 in
Heater 16 x 16 in, 1,625 W 16 x 20 in, about 2,050 W
120 V circuit 12.5 A, dedicated 15 A circuit, NEMA 5-15R 16.5 A, dedicated 20 A circuit, NEMA 5-20R
240 V version NEMA 6-15R NEMA 6-15R
Belt speed 0.6 to 7.4 ft per minute 0.6 to 7.4 ft per minute
Heater height 2 to 7 in above the belt 2 to 7 in above the belt
Largest image Heater width minus 4 in Heater width minus 4 in

Maintenance at a glance

When What to do
Every shift Keep the belt moving while the heater is above 300°F. Turn off the breaker and unplug at the end of the shift.
Regularly Check the ink temperature at the dryer exit and adjust the heat
Occasionally Check belt tracking and chain tension (0.25 to 0.38 in of total slack)

Where to put it

Use a bench or stand that can carry the weight (about 89 lb for the D-100 and 116 lb for the D-1000) on a flat surface. Plug into a new commercial-duty receptacle on its own circuit. Never put anything on top of the chamber, never leave the dryer running unattended, and don't run it with the chain guard or covers off. Vastex sells an exhaust option for both models that pulls fumes and moisture out of the chamber, which helps with water-based inks and DTF adhesive fumes.