Support
Machine type
Brand
Epson SureColor F2270

Epson SureColor F2270 support

Covers: F2270

Everything for keeping an Epson SureColor F2270 printing on garments and on DTF film: Epson's daily, weekly and monthly routine, which liquid goes where, film printing settings, error messages and Epson's manuals. The F2270 replaced the F2100 but is a different machine, with 800 ml UltraChrome DG2 ink packs, a Maintenance Liquid pack and its own maintenance menus.

Epson SureColor F2270 hybrid DTG and DTF film printer, front left view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Epson's video: unboxing and initializing the F2270

More videos

Epson: cleaning the F2270 suction cap
Epson: cleaning around the F2270 print head
Epson: maintenance cleaning on the F2270
Epson: preparing the F2270 for storage

Embedded from the manufacturer's official channel.

About the Epson SureColor F2270

The SureColor F2270 is Epson's hybrid printer: it prints directly on garments (DTG) and on DTF transfer film. It uses UltraChrome DG2 ink in 800 ml packs: cyan, magenta, yellow, black and two white packs, plus a separate Maintenance Liquid pack. It has a PrecisionCore MicroTFP print head with Nozzle Verification Technology, automatic garment thickness detection, a 4.3 inch touchscreen and Epson's Garment Creator 2 software. Epson says all of its F-series platens fit the F2270, including F2000 and F2100 platens.

The printer runs in White ink mode, Color ink mode or High speed color mode. High speed color mode is chosen at first setup and can't be changed later, and it can't print film, because film needs white ink.

Epson's maintenance schedule at a glance

How often What to do Time
Every working day Rock the two White ink packs, print a nozzle check, run Auto Cleaning or a Light cleaning on channels with gaps About 5 min
Every week Clean the suction cap. If the printer sits idle, turn it on at least once every 7 days 5 to 10 min
Every month Rock the color ink packs. Check for firmware and Garment Creator 2 updates About 5 min
When prompted Replace the head cleaning set, clean the sensor cover, the encoder strip and around the head, replace the waste ink bottle 5 to 10 min each
Idle 2 weeks to a month Switch from White ink mode to Color ink mode (uses two Cleaning Liquid packs) Varies
Idle a month or more Run Keeping Preparation with Cleaning Liquid packs About 45 min

Where to put it

Epson rates the F2270 for 50 to 95°F and 20 to 80% humidity, and recommends 59 to 77°F and 40 to 60% for best results, at 6,561 feet of altitude or lower. Keep it away from heaters, air-conditioning or vent exhaust and your pretreatment machine, which all dry out the head. Above 86°F around the head, the printer runs automatic cleanings more often. Unlike the F2100, Epson recommends leaving the F2270 switched on: it runs a cleaning every time it powers up, so frequent on and off cycles use more ink.