Support
Machine type
Brand
xTool F2 Ultra

xTool F2 Ultra support

Covers: F2 Ultra (60 W MOPA + 40 W diode) · F2 Ultra single laser (60 W MOPA)

Everything for running an xTool F2 Ultra: connecting it to xTool Studio, finding xTool's official material settings, cleaning the field lens and fan, and the safety rules for a Class 4 laser. xTool Studio has replaced xTool Creative Space (XCS), which xTool no longer maintains.

xTool F2 Ultra enclosed laser engraver with its touchscreen controller

Setup & first print

Daily & weekly maintenance

Troubleshooting

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch xTool's video: xTool F2 Ultra 60W MOPA and 40W diode dual laser

More videos

Color engraving on metal with the F2 Ultra

Embedded from the manufacturer's official channel.

About the xTool F2 Ultra

The F2 Ultra is xTool's enclosed desktop galvo laser. The dual-laser version has a 60 W infrared MOPA laser (1064 nm) for metals and a 40 W blue diode laser (445 nm) for wood, acrylic, leather and similar materials. The single-laser version has the MOPA laser only. The internal working area is 220 x 220 mm, and it connects over USB, Wi-Fi or IP address. It comes with a touchscreen controller for focusing, framing and start/stop.

Both versions are Class 4 laser products. Read xTool's safety guide before the first job, and keep the enclosure closed with Stops when enclosure opened turned on in the device settings.

Maintenance at a glance

Part When What to do
Field lens Engraving turns shallow, or cuts stop going through Power off, remove the key, wipe gently with a lint-free cloth and absolute ethanol
Fan module Smoke escapes the enclosure or airflow feels weak Remove the magnetic guard, take out the fan module and brush it clean. Never rinse it in water.
Enclosure When dirty Wipe with a barely damp microfiber cloth
Work area After every job Remove scraps and residue, check that nothing is smoldering

Where to put it

Set it on a stable, flat, non-flammable surface, away from paper, solvents and other flammables. Run the exhaust pipe outdoors or into an air purifier. xTool rates it for 15 to 30°C (59 to 86°F) and says never to run it below 0°C. If it will sit unused for a long time, put the field lens protector back on to keep dust off.