Support
Machine type
Brand
DTF Station Seismo V36R DTF Powder Shaker and Dryer

DTF Station Seismo V36R DTF Powder Shaker and Dryer support

Covers: Seismo V36R

The Seismo V36R is a 36 inch roll-to-roll powder shaker and dryer for high-volume DTF printers such as the Prestige X6. It powders the film automatically, recirculates unused powder, and cures on a vacuum conveyor belt under upper and lower dryers. It needs 220 V and must be installed by qualified people. Start here for settings, daily cleaning, oil drainage and the manual.

DTF Station Seismo V36R powder shaker and dryer, side view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch DTF Station's video: Seismo V36R 36-inch powder applicator and dryer overview

Embedded from the manufacturer's official channel.

About the DTF Station Seismo V36R DTF Powder Shaker and Dryer

Film comes off the printer, passes under the powder box, runs between the shaking paddle and the platform, then travels on a vacuum belt through the dryers before winding onto the take-up core. A sensor behind the film starts and stops the belt, powder and shaking in Automatic mode, and an auto-recirculating system returns unused powder to the box. Three exhaust ports join into one outlet for a fume purifier.

Key specs

Max film width 36 in
Power 220 V, 50/60 Hz, 9000 W, 40.9 A. Ground wire must be connected
Powder box 3 kg maximum
Size and weight About 45 in wide x 130 in deep x 45 in high, 700 lb
Fume extraction DTF Station smoke filter, or another unit rated 36 to 202 m³/h

Maintenance at a glance

When What to do
End of every day Clean powder out of the shaker chamber, shaking paddle, powder box and its rubber seal, media tension bar, front heating plate and control panel. Empty the powder box completely. Open the front dryer for 1 hour so oil drains into the collection tray.
Weekly or as needed Drain the oil collection tray
Before reusing powder Sift it through a 60-mesh screen
When extraction gets weak Replace the smoke filter

Where to put it

Use a level, stable, well-ventilated spot indoors, away from heaters, air conditioners, direct sunlight, water and dust, with the power plug easy to reach. DTF Station specifies 68 to 83°F (20 to 28°C) and 40 to 60% humidity while running, and 59 to 86°F (15 to 30°C) and 30 to 80% humidity when idle, with no condensation. Moving, unloading and installing the V36R should be done by trained people with the right equipment.