Support
Machine type
Brand
DTF Station Prestige A3+ and A3+ R

DTF Station Prestige A3+ and A3+ R support

Covers: Prestige A3+ · Prestige A3+ R

The Prestige A3+ and A3+ R are desktop DTF printers built on an Epson printer engine, connected by USB and driven by DigiRip (CADlink Digital Factory). They are no longer sold new, but we still support them and stock their parts. Most problems trace back to three things: a skipped daily routine, settled white ink, or a dirty encoder strip or capping station.

DTF Station Prestige A3+ R desktop DTF printer, three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Watch DTF Station's video: Prestige A3+ initial setup

More videos

Introducing the Prestige A3+ R
Prestige A3+ R opening procedure
Prestige A3+ R nozzle check and head cleaning
Reading the error code on the Prestige A3+ R

Embedded from the manufacturer's official channel.

About the DTF Station Prestige A3+ and A3+ R

The Prestige A3+ is a desktop direct-to-film printer for transfers up to A3+ size. The A3+ R is the roll-fed version. Both are built around an Epson print engine and print head, so the front panel uses Epson-style buttons and lights (power, ink and paper) instead of a screen. They connect to a Windows PC by USB and print from DigiRip, using the Prestige A3 DTF V2 printer driver.

Because the engine is Epson-based, the panel lights are how the printer tells you something is wrong. Learn the difference between lights that blink together and lights that take turns: it points to very different fixes.

Maintenance at a glance

How often What to do
Start of every day Empty the waste bottle if needed, shake the white ink, check the dampers are seated, run a head cleaning and print a nozzle check on film
End of every day Clean the capping station, wiper and the area around the print head with DTF cleaning solution, then park the head on the cap
Every week Clean the encoder strip and the printer bed
About once a year Replace the dampers. Expect to replace the print head, cap and wiper every 1 to 2 years with regular use

Where to put it

Aim for a steady room around 70 to 75°F with 35 to 45% humidity. Keep the printer out of direct sun and away from heaters, fans and air-conditioning vents: air blowing across the print head dries the white channels first. Put it on a sturdy, level table and cover it at night to keep dust off.