Support
Machine type
Brand
STS XPD-924D DTF Printer (Mutoh)

STS XPD-924D DTF Printer (Mutoh) support

Covers: XPD-924D

The STS XPD-924D is a 24 inch direct-to-film printer built by Mutoh, with two staggered print heads, white ink circulation, automatic cleaning in sleep mode and the Mutoh Status Monitor. It runs only on STS XPD2 ink. STS wants it left on, the white cartridges shaken every day, and the printer used regularly: idle time of more than 5 business days without a Long Store risks white ink clogs and can void the warranty.

STS XPD-924D direct-to-film printer on its stand, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Manuals & downloads

Watch STS Inks' video: CR maintenance on the XPD-924D

More videos

STS Inks: the XPD-924D 24 inch DTF printer
STS Inks: XPD-924D from print to finished transfer

Embedded from the manufacturer's official channel.

About the STS XPD-924D DTF Printer (Mutoh)

The XPD-924D prints up to 609 mm (24 inches) wide with two staggered print heads and four head heights. It runs STS XPD2 ink in 500 ml cartridges: black, cyan, magenta, yellow and two white, each with an S/C card attached. It connects by Gigabit Ethernet, has a touch panel and white ink circulation, and a 2,000 ml waste ink tank. You run maintenance from the panel or the Mutoh Status Monitor (MSM).

Maintenance schedule at a glance

How often What to do
Every day, before waking the printer Shake both white cartridges, run CR Maintenance and clean the capping station, wiper blade and spit pad, check the platen and media guards, print a nozzle check B
Every week Deep clean of the capping station, wiper blade and spit pad, their drain paths, and the print head guards
Every month Inside cleaning
Every 3 to 4 months Long Store to flush sediment from the ink lines
Idle more than 5 business days Long Store before the break
Every 12 months Replace the cleaning wiper

Keep it running

STS's usage targets: at least one full set of 500 ml cartridges a month, or at minimum print the STS Inks Test Print (22.5 x 16 inches) three times a week. In sleep mode, set auto cleaning every 6 hours, or every 4 hours or less in hot or dry rooms. Keep the printer at least 50 cm (about 1.6 ft) from any powder shaker.

Where to put it

The operation manual specifies 20 to 30 °C (68 to 86 °F) and 35 to 50% humidity with no condensation, no direct sunlight, little dust and static. Leave it powered on, on a surge protector, and STS recommends at least a 500VA UPS.