Support
Machine type
Brand
xTool P2S

xTool P2S support

Covers: xTool P2S

Everything for running an xTool P2S desktop CO2 laser: coolant, connecting to xTool's software, cleaning the three mirrors and the exhaust filter screens, and safety. xTool recommends cleaning the mirrors every 2 to 4 hours of use and the filter screens every 4 hours of continuous running.

xTool P2S desktop CO2 laser cutter, front three-quarter view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch xTool's video: xTool P2S desktop CO2 laser

Embedded from the manufacturer's official channel.

About the xTool P2S

The P2S is xTool's desktop CO2 laser cutter. It has a 600 x 305 mm processing area, two 16 MP cameras, a water-cooled laser tube, a built-in air pump and a red-dot pointer to help with mirror alignment. The beam travels from the tube over three mirrors to the focus lens, so clean optics matter more on this machine than on a diode laser. US units run on 110 V only.

Maintenance at a glance

How often What to do
Every 2 to 4 hours of use Clean the three laser mirrors with isopropyl alcohol and a lint-free cloth, then check the optical path
Every 4 hours of continuous use Remove the magnetic filter screens, rinse with clean water and brush clean
After every job Clear scraps and residue from the bed
When airflow drops Clean the smoke exhaust fan. Do not submerge it.
When the H or L light shows The coolant is too hot (H) or too cold (L). Stop and let it recover.

Coolant

Fill the tank before the machine is plugged in, using xTool's antifreeze and purified water in the amounts given for your coldest local temperature. Never use tap water.