Support
Machine type
Brand
Viper MINI handheld DTG pretreatment machine

Viper MINI handheld DTG pretreatment machine support

Covers: Viper MINI

The Viper MINI is i-Group Technologies' compact rolling pretreat sprayer. You guide it down the shirt by its handle while a drive wheel moves it at a set speed. Speed (20 to 100%) and nozzle height set how much pretreat goes down. Viper requires a hot water flush at the end of every day and whenever it sits for more than 30 minutes, because pretreat left inside will ruin it.

Viper MINI handheld DTG pretreatment sprayer with handle, speed display and wheels

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Viper's video: Viper MINI introduction and use

More videos

Viper: Viper MINI demo
Viper: MINI menu defaults and factory reset

Embedded from the manufacturer's official channel.

About the Viper MINI handheld DTG pretreatment machine

The MINI comes from i-Group Technologies, the maker of the Viper XPT-1000 and MAXX. Instead of a cabinet, it's a small sprayer on wheels. You hold the handle, press the Spray button with your thumb, and a powered drive wheel carries it down the shirt at a steady speed while the nozzle sprays several inches in front of the wheels. Let go of the button and it stops moving and spraying.

What's in the box

  • The MINI, its handle and power supply
  • An 18 x 24 inch foam platen that holds the shirt still
  • A fluid supply line with filter, plus loom sheathing and zip ties to bundle it with the power cable
  • A spare spray tip, a spray head filter and a cup for priming
  • Starter bottles of Image Armor PLATINUM and LIGHT pretreat and Image Armor cleaning solution

What matters for upkeep

  • Speed runs from 20% (slowest, most pretreat) to 100% (fastest, least).
  • Nozzle height sets the spray width: lower is narrower, higher is wider. The height marker reads 7, 14 and 18 inches.
  • The nozzle comes off with a half twist for cleaning.
  • The drive wheel has to grip the fabric. Press down enough to keep contact, but don't push or drag it.

Viper's care schedule at a glance

When What to do
During production Wipe pretreat off the front spray side, body, height slide and wheels so it can't drip on shirts
Idle more than 30 minutes Flush with water. Never let pretreat dry on the spray tip.
End of every day Flush the line with air, then warm or hot clean water, and wipe the machine down
Cleaning the tip Only the soft toothbrush. Toothpicks or needles damage the tip.