Support
Machine type
Brand
Mimaki TxF330-800

Mimaki TxF330-800 support

Covers: TxF330-800

Everything for keeping a Mimaki TxF330-800 DTF printer running: first setup with RasterLink, the before-work and weekly cleaning Mimaki asks for, what the display messages mean, and Mimaki's own manuals. Keep the main power switch on so the printer can run its automatic anti-clog maintenance.

Mimaki TxF330-800 DTF printer, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Manuals & downloads

About the Mimaki TxF330-800

The TxF330-800 is Mimaki's 800 mm (31.5 in) roll-to-roll direct-to-film printer. It uses Mimaki PHT50 heat transfer pigment ink in two set-ups: 4 colors plus white (CMYK and W) or 6 colors plus white, which adds Sky Blue and Pale Pink. It has two staggered print heads, an automatic nozzle check unit (NCU), automatic feed and drop position correction (DAS), and three media heaters (pre, print and post) that go up to 50°C.

Maintenance liquid is fed from its own cartridge, waste ink goes to a 2,000 ml bottle, and the printer connects to your RIP computer by gigabit Ethernet (recommended) or USB 2.0. Mimaki's RIP is RasterLink.

Mimaki's maintenance schedule at a glance

When What to do
Before work each day Clean the wiper and its bracket, the cap rubber and the underside of the carriage
Weekly, before work Shake each color cartridge 20 times
End of each week The daily items plus the NCU, DAS sensor, ink discharge channel, media sensors, media holders, platen and covers. Check the waste ink level.
Monthly Clean the washing tray
Idle a week or more Run Custody Wash and leave the main power on

Shake the white cartridges 40 times whenever the printer has been on for more than 24 hours or the display asks you to, and 100 times after 3 or more days.

Where to put it

Mimaki rates the TxF330-800 for 20 to 30°C (68 to 86°F) and 35 to 65% relative humidity with no condensation. Accuracy is best at 20 to 25°C, and the room shouldn't swing more than 10°C in an hour. It needs a single-phase 100 to 120 V (8 A) or 200 to 240 V (4.5 A) outlet, and Mimaki's dust figure is that of a typical office.