Support
Machine type
Brand
Geo Knight DC16 and DC16AP Digital Combo Swing-Away Presses

Geo Knight DC16 and DC16AP Digital Combo Swing-Away Presses support

Covers: DC16 · DC16AP (controller and attachments)

The Geo Knight DC16 Digital Combo is a 14 x 16 in swing-away press whose heat platen unplugs and swaps for cap, mug and plate attachments, even while hot. It uses the Digital Knight controller with 70 presets, a prepress timer and a 0 to 9 pressure bar graph. The DC16AP is the air-operated, push-button version with the same controller and attachments.

Geo Knight DC16 14x16 Digital Combo swing-away heat press

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Geo Knight's video: DC16APT with bottom heat

More videos

Digital Knight control and instructions
Digital Knight heat press control system

Embedded from the manufacturer's official channel.

About the Geo Knight DC16 and DC16AP Digital Combo Swing-Away Presses

The Digital Combo swings the heat platen away from the lower table, so you load with no heat over your hands. What sets it apart is the modular heat platen: a safety-locked connector and a quick release pin let you swap the 14 x 16 in platen for a cap, mug or plate attachment in under a minute without waiting for it to cool. The DC16AP is the fully automatic version: it closes with air at the push of a button and uses the same controller and attachments.

Key specs

Platen 14 x 16 in, interchangeable lower tables
Controller Digital Knight: 70 presets, prepress timer, 0 to 9 pressure bar graph, odometer
Attachments Cap, full-wrap mug, plate, bottom heat
Power DC16: 120 V, 1800 W, 15 A
Thickness Presses items up to 2 in thick

Care at a glance

When What to do
Every day Leave the platen up, never resting on the pad while it heats
Clamp feels stiff Clean and re-lube the clamp pins and platen posts with a clear high-temperature lubricant
Press won't lock Clamp pins or holes are worn. Contact us for a replacement clamp
Pad dry or cracked Replace the silicone pad or table

Where to put it

Geo Knight suggests a firm bench 25 to 30 in high, and you can bolt the base down through its rear holes. Tie the power cord to the back post so swinging the head never pulls on the inlet under the head.