Support
Machine type
Brand
Geo Knight DK Digital Clamshell Presses: DK20, DK16, DKA Auto, DK8 Label and DK7 Cap

Geo Knight DK Digital Clamshell Presses: DK20, DK16, DKA Auto, DK8 Label and DK7 Cap support

Covers: DK20 · DK16 · DKA Auto Clamshell (DK20A, DK16A) · DK8 · DK8T · DK7 · DK7T

Geo Knight's DK clamshells are manual heat presses with the Digital Knight controller: digital temperature and timer, a prepress timer and 70 presets. The DK20 (16 x 20 in) and DK16 (14 x 16 in) add a 0 to 9 pressure bar graph, and the DKA versions open on their own at the end of the timer. The DK8 label press and DK7 cap press use the same controller on a smaller frame, without the pressure bar graph.

Geo Knight DK20 16x20 digital clamshell heat press

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Geo Knight's video: the DK20 clamshell heat press

More videos

DK clamshell auto pop-up pressure setting tutorial
Digital Knight control and instructions
Digital Knight heat press control system

Embedded from the manufacturer's official channel.

About the Geo Knight DK Digital Clamshell Presses: DK20, DK16, DKA Auto, DK8 Label and DK7 Cap

The DK clamshells open wide and lift the heat platen well back from the pad, so you can load without reaching under a hot surface. You set pressure with the black knob on top of the head and lock the press with a firm two-handed close. Gas springs lift the head when you open it. The DKA (DK20A and DK16A) adds an electromagnet that holds the handle down while the timer counts, then lets the press pop open. A DK20 or DK16 with the newer frame can be upgraded to auto-release later.

Models and key specs

Model Platen Notes
DK20 16 x 20 in Bar graph, 70 presets, 120 V 15 A or 220 V
DK16 14 x 16 in Same features as the DK20, 120 V 13 A or 220 V
DKA 16 x 20 or 14 x 16 in Auto pop-up with a hover position for curing
DK8, DK8T 6 x 8 in Label press, 6 x 8, 3 x 5 and 3 x 3 in tables
DK7, DK7T 4 x 7 in Curved cap press, Standard and Euro forms

Care at a glance

When What to do
Every day Leave the press open between jobs, never resting on the pad while it heats
Now and then Check the pressure screw threads and the linkage pivot bolts for looseness
Head won't stay open Gas springs are worn. They are replaceable
Pad dry or cracked Replace the silicone pad or the table

Where to put it

Geo Knight recommends a firm bench 27 to 32 in high and bolting the base down through its front and rear holes, because clamshells can hop when they open, especially with auto-release. Keep the power cord free of any pull on the inlet at the back of the control box.