Support
Machine type
Brand
DTF Station Prestige R1

DTF Station Prestige R1 support

Covers: Prestige R1

The Prestige R1 is DTF Station's entry-level 13 inch roll DTF printer, with one Epson F1080 print head, a white ink circulation system, and Pilot printer software with NeoStampa RIP over Ethernet. Do the beginning-of-day routine every morning, clean around the head every night, and don't print until the nozzle check is 90% or better. Keep the white circulation knob at 20% after any ink fill.

DTF Station Prestige R1 13 inch DTF printer, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Watch DTF Station's video: Prestige R1 assembly

More videos

Prestige R1 basic operation with the Phoenix Air oven
Prestige R1 daily, weekly and as-needed maintenance
Prestige R1 beginning of day procedures
Prestige R1 deep dive into NeoStampa

Embedded from the manufacturer's official channel.

About the DTF Station Prestige R1

The Prestige R1 prints DTF transfers from a 13 inch film roll with a single Epson F1080 print head (CMYK plus white). Its White Ink Management System circulates white ink so it doesn't settle, it cleans itself on a timer while idle, and it warns you when ink runs low. It connects to a Windows PC by Ethernet cable (no Wi-Fi), and prints through two programs: Pilot, which runs the printer, and NeoStampa, the RIP where you lay out your designs. Some earlier units shipped with DigiRip instead of NeoStampa.

Key numbers: up to 14 sq ft per hour at 720x1080 dpi, about 90 lbs (lift it with two people), and a PC running Windows 11 with an Intel i5 or i7, 8 GB of RAM or more, an SSD and an Ethernet port. Mac and Surface tablets won't run Pilot.

Maintenance at a glance

How often What to do
Start of every day Shake white ink, check ink and waste levels, short Fill Ink, two head cleanings, nozzle check at 90% or better
End of every day Clean around the print head, wiper blade and cap with DTF cleaning solution, park the head, power off and cover
Every week Clean the encoder strip, home position, pinch rollers, bed and media guides. Empty and test the waste bottle alarm
Monthly Stir the white ink tank (only when it's below half full)
As needed Grease the carriage rail with white lithium grease paste

Where to put it

A steady room around 70 to 75°F with 35 to 45% humidity (30% is the low edge), out of direct sun, on a sturdy level table. Keep fans and air-conditioning from blowing on the printer. If you don't print every day, leave it powered on so it can circulate white ink and clean itself.