Support
Machine type
Brand
Viper MAXX pretreatment machine

Viper MAXX pretreatment machine support

Covers: Viper MAXX

The Viper MAXX is i-Group Technologies' production pretreatment machine, with a touchscreen, spray presets and barcode support. Purge it with water at the end of every day and leave only water inside, run cleaning solution through it weekly, and clean and oil the rails with the light oil Viper specifies. Its built-in spray step test helps you find the right amount of pretreat for each shirt.

Viper MAXX DTG pretreatment machine with touchscreen and yellow platen

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch Viper's video: MAXX setup and installation

More videos

Viper: cleaning and oiling the MAXX rail systems
Viper: MAXX Auto Clean setup and routine
Viper: MAXX spray presets and custom spray areas
Viper: changing the amount of pretreatment on the MAXX

Embedded from the manufacturer's official channel.

About the Viper MAXX pretreatment machine

The MAXX is i-Group Technologies' touchscreen pretreatment machine for higher-volume DTG shops. It sprays up to about 19 x 24 inches, stores 4 quick spray amounts and 30 custom spray areas, and can read barcodes to load a preset per shirt style. There is no drawer: the platen sits open in front of the spray gantry.

What matters for upkeep

  • One fluid supply tube feeds the machine. You swap that tube between pretreat, water and cleaning solution, and use the Purge button on the side to push each through.
  • Auto Clean briefly purges the spray tip during idle time while the machine is on, to keep the tip wet.
  • Steps between spray passes are adjustable, so you can tune the overlap as the spray tip wears. Viper includes a tip gauge.
  • Use only the power adapter supplied with the machine, and disconnect it before cleaning.
  • Keep the bellows installed and the lids on to keep pretreat mist out of the mechanics.

Viper's maintenance schedule at a glance

How often What to do
Every working day Purge the pretreat out, purge water through for 30 seconds, and leave only water in the machine
Every week Purge cleaning solution for 30 seconds, flush with water, clean the rails with rubbing or denatured alcohol
Over time Oil the rails with 3-in-1 original oil or a lightweight slide oil only. Grease slows the spray and can bind the carriage.

Where to put it

Viper rates the MAXX for 41 to 104°F (5 to 40°C) and 0 to 90% humidity. Its footprint is about 39.5 x 45.5 inches, and Viper asks for 3 feet of clear space around it for use and maintenance. Set it on a level table and lift it with two people. In some shops the noise near the touchscreen may call for hearing protection.