Support
Machine type
Brand
STS VJ-628D DTF Printer (Mutoh)

STS VJ-628D DTF Printer (Mutoh) support

Covers: VJ-628D · VJ-628D-C

The STS VJ-628D is a 24 inch direct-to-film printer from STS Inks, built on a Mutoh ValueJet chassis and run from the Mutoh Status Monitor (MSM). Most problems on this machine come from three things: white ink that was not shaken, a print head that touched the film, and a printer that sat unused without Long Store. The guides below cover each one with STS's own procedures.

STS VJ-628D direct-to-film printer on its stand, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch STS Inks' video: shaking the whites before waking the printer

More videos

STS Inks: wet capping the 628 and 724 after a head strike
STS Inks: 628 and 724 rail maintenance and grease
STS Inks: 628 and 724 heat platen maintenance
STS Inks: clearing a clogged 628 or 724 waste tank

Embedded from the manufacturer's official channel.

About the STS VJ-628D DTF Printer (Mutoh)

The VJ-628D is STS Inks' 24 inch DTF printer. It prints on roll film up to 630 mm (about 24.8 in) wide with a maximum print width of 620 mm, connects to your computer by Ethernet only, and is controlled through the Mutoh Status Monitor (MSM) and the VJ-628 printer driver. The 8-channel setup runs CMYK plus two white and two cleaning channels. It has a built-in cutter, a platen heater adjustable from 30 to 45 °C, and a 1,500 ml waste ink tank that you empty by hand.

Maintenance schedule at a glance

How often What to do
Every working day Shake the white ink (cartridges or bags), print a nozzle check before and after printing, clean only if there are gaps
Every week Clean the cleaning wiper and around the print head with a dry cleaning stick. If the printer is idle a week or more, run a head cleaning once a week
Every month Clean inside: brush the pressure arms, wipe the platen, media guide and grid roller with a well wrung damp cloth
About every 2 months Check the flushing box absorber and replace it when ink lumps rise above its frame
When the error light and buzzer say so Empty the waste ink tank and reset the waste ink counter in MSM
Idle more than 5 days STS recommends flushing the lines with Long Store

Where to put it

The STS manual specifies 68 to 75 °F and 45 to 55% humidity, with no condensation and no swings of more than 4 °F or 5% humidity per hour. Keep it out of direct sunlight, in a dust-free spot, and on a UPS or surge protector. STS recommends using the printer at least once a week, because nozzles left idle can clog.