Support
Machine type
Brand
Seismo L16R and L24R DTF Powder Shaker and Dryer

Seismo L16R and L24R DTF Powder Shaker and Dryer support

Covers: Seismo L16R · Seismo L24R

Everything for running a Seismo L16R (18 inch film) or L24R (24 inch film): setup, the daily end-of-day routine, starting temperatures, and fixes for a stopped belt, film that won't feed, or a blank screen. Both are 220 V machines with automatic powder recirculation, a vacuum conveyor belt and a motorized take-up reel, and they share the same controls and maintenance.

DTF Station Seismo L24R DTF powder shaker and dryer with take-up reel, side view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: running the Seismo L16R and L24R

Embedded from the manufacturer's official channel.

About the Seismo L16R and L24R DTF Powder Shaker and Dryer

The Seismo L16R and L24R are DTF Station's roll-fed powder shaker and dryers. Printed film comes off the printer over a heated front plate, gets coated with hot-melt powder in the powder station, has the excess shaken off and pulled back for reuse, then cures in the dryer and winds onto a motorized take-up reel. A sensor behind the film starts and stops the machine in Auto mode, so it follows your printer.

Seismo L16R Seismo L24R
Max film width 18 in (45 cm) 23.62 in (60 cm)
Power 220 V, 16 A, 3.5 kW 220 V, 24 A, 5.2 kW
Usually paired with Prestige L2 Prestige XL2, XL2 Pro, XL3 and XL4

Maintenance at a glance

How often What to do
Every 30 minutes while printing Check for banding, powder sticking to bare film, powder level, and how the cured prints look on the reel
End of every day Feed out the last prints, recover and seal the powder, empty the powder box, run the purifier, cool and wipe the dryer, oven vent and powder station
Weekly or as needed Clean the film sensor, clean the glycerin container, clean the powder station mesh, empty the oil collection tray

Where to put it

Put it on a level floor, out of direct cold airflow from air conditioning, away from heaters and out of direct sunlight. DTF Station recommends a room at 20 to 28°C (68 to 82°F) and 40 to 60% relative humidity. It needs a grounded 220 V supply sized for the model, and some installs must be hard-wired by an electrician.