Support
Machine type
Brand
Epson SureColor F3070

Epson SureColor F3070 support

Covers: F3070

The Epson SureColor F3070 is Epson's industrial direct-to-garment printer. Epson treats routine care as the owner's job: shake the white ink and run a nozzle check every day, clean the suction cap and around the head every week, and check the flushing pads and air filters every month. Epson's extended service plans don't cover that routine maintenance.

Epson SureColor F3070 industrial direct-to-garment printer with its ink unit, front left view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Epson's video: cleaning the F3070 suction cap

More videos

Epson: cleaning around the F3070 print heads and metal edges
Epson: cleaning the F3070 sensor cover
Epson: loading a T-shirt on the F3070 grip pad platen
Epson: aligning the F3070 print head

Embedded from the manufacturer's official channel.

About the Epson SureColor F3070

The SureColor F3070 is Epson's production direct-to-garment printer. It runs UltraChrome DG ink from 1.5 liter ink supply units in a separate ink unit: cyan, magenta, yellow, black and white, plus a Maintenance Liquid unit. It prints in White ink mode or Color ink mode at up to 1200 × 1200 dpi. It weighs about 727 pounds. In North America Epson requires installation by an authorized dealer, and says damage from an unauthorized installation isn't covered by the Epson warranty.

Epson's required maintenance at a glance

How often What to do
Every day Shake (agitate) the White ink, print a nozzle check, run head cleaning cycles as needed
Every week Clean the suction cap and clean around the print head
Every month Agitate the color ink. Check for firmware and software updates. Check the flushing pads and air filters
As needed Replace the head cleaning set, the anti-drying cap tops and the air filters
Idle 2 weeks to a month Switch from White ink mode to Color ink mode
Idle a month or more Run Keeping Preparation with six Cleaning ink supply units and a new waste ink bottle

If you skip storage maintenance and don't print for a while, Epson says to turn the printer on at least once every seven days, otherwise a nozzle can clog for good.

Where to put it

Epson rates the F3070 for 50 to 95°F and 20 to 80% humidity, and recommends 59 to 77°F and 40 to 60%. Keep it away from heat sources and out of the airflow from vents, air conditioners and pretreatment machines, which dry and clog the head. Plan for a large clear area around it: Epson's installation diagram calls for about 118 by 102 inches of floor space.