Support
Machine type
Brand
Hotronix Auto Open Cap Press and 360 IQ Hat Press

Hotronix Auto Open Cap Press and 360 IQ Hat Press support

Covers: Auto Open Cap Press (STXC) · 360 IQ Hat Press (STXCP)

Both are Hotronix clamshell cap presses: you lock the cap on the lower platen with the hold-down lever, pull the handle down, and an electromagnet holds the press closed until the timer ends and gas shocks lift the heat platen. The Auto Open Cap has an LED display, two timers and a 0 to 9 pressure readout. The 360 IQ Hat Press adds a heated lower platen, a touchscreen with presets, and Wi-Fi for the IQ Portal.

Hotronix Auto Open Cap heat press, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Manuals & downloads

Watch Hotronix's video: Cap Heat Press unboxing and set up

More videos

360 IQ Hat Press: adjusting the pressure
Mastering the Hotronix 360 IQ: how to print hats

Embedded from the manufacturer's official channel.

About the Hotronix Auto Open Cap Press and 360 IQ Hat Press

Hotronix makes two cap presses that AA sells. The Auto Open Cap Press heats from the top only and is run from a small LED panel. The 360 IQ Hat Press heats from the top and the bottom, which helps with patches and emblems, and is run from a touchscreen. Both close like a clamshell, hold the cap with a hold-down lever under the lower platen, and open on their own when the timer ends.

Key specs

Spec Auto Open Cap 360 IQ Hat Press
Controls LED display, Mode and +/- buttons Touchscreen with presets and users
Heat Upper heater only Upper and lower heaters, set separately
Temperature 176 to 430°F (79 to 220°C) Top and bottom targets on the Home Screen
Timers Time #1 and Time #2 Multi-step presets
Pressure Knob, 0 to 9 readout Knob, 0 to 9 readout
Idle Sleeps after 2 hours Standby, Power Save and Auto On

Care at a glance

When What to do
First setup Remove the packaging bolt on top of the press before you switch it on
Before cleaning Switch off, unplug and let the heater cool
Residue on the heater Wipe with a dry cloth. For more, Hotronix suggests abrasive-free mechanic's hand soap on a cloth
Every day Check the power cord. Don't run the press with a damaged cord

Where to put it

Hotronix wants a sturdy stand at least 36 in long, 24 in wide and 29 in high, and a clean, clear work area. Plug into a grounded outlet that isn't shared with another heat press or other high-draw equipment. If you must use an extension cord, keep it short and no lighter than 12 gauge.