Support
Machine type
Brand
DTF Station Prestige R2 (original)

DTF Station Prestige R2 (original) support

Covers: Prestige R2

Support for the original DTF Station Prestige R2, the 13-inch DTF printer with two Epson XP600 heads that came before the R2 Pro. It shares its frame, capping station, dampers, belt and most repair procedures with the R2 Pro, but its heads, cap tops and some software rules are different. Most R2 printers run Hosonsoft (PrintExp) as the control software with DigiRIP or NeoStampa as the RIP.

DTF Station Prestige R2 DTF printer, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Software & drivers

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: introducing the Prestige R2

More videos

Prestige R2 operation
Prestige R2 end-of-day maintenance
Prestige R2 weekly maintenance

Embedded from the manufacturer's official channel.

About the DTF Station Prestige R2 (original)

The original Prestige R2 is a 13-inch desktop DTF printer with two Epson XP600 print heads: the left head prints CMYK and the right head prints white. It looks almost identical to the R2 Pro and shares many parts with it, including the capping station assembly, dampers, carriage belt, encoder strip and bearing. The heads, cap tops, daughterboard and ink tubes are different, so check the model on your serial sticker before ordering parts.

Most R2 printers run Hosonsoft (PrintExp) as the control software. The RIP is DigiRIP, or NeoStampa if the printer has been upgraded. Do not move an R2 from Hosonsoft to Pilot on your own: some R2 units lack hardware that Pilot needs, so talk to us first.

What's different about XP600 heads

  • An XP600 has far fewer nozzles per color than the R2 Pro's i1600, so a few missing nozzles show up as banding sooner. Keep up with the daily nozzle check.
  • DTF Station's technicians keep the during-print Auto Clean setting off on XP600 printers. Leave Pre-Flashing on.
  • Never wipe the face of an XP600 head as a clog fix. Use the wet-cap method in our nozzle guide instead.

Maintenance schedule at a glance

When What to do
Start of every day Shake the white ink bottle and print a nozzle check. Print only when at least 90% of the nozzles are firing.
End of every day Clean around the head, the capping station, the wiper blade and the cap tops with cleaning solution. Wet the cap sponges, dock the head, run one cleaning. Leave the printer on.
Every week Empty the waste ink bottle, clean the encoder strip with 90% or stronger isopropyl alcohol, and wipe the pinch rollers with a dry lint-free cloth.
About once a year Replace dampers and inlet filters. Expect to replace heads, cap tops and the wiper blade every 1 to 2 years.

Where to put it

Aim for 70 to 75°F and 35 to 45% humidity, away from fans, air conditioning vents and direct sun. Keep the waste ink bottle lower than the printer and connect the printer straight to the computer by Ethernet.