Support
Machine type
Brand
DTF Station Arc 127 automatic cutter for DTF and UV DTF film

DTF Station Arc 127 automatic cutter for DTF and UV DTF film support

Covers: Arc 127

The Arc 127 is DTF Station's automatic contour cutter for printed DTF and UV DTF film, on rolls or single sheets. A camera finds the registration marks printed next to your designs, a vacuum bed and air-powered clamp hold the film, and the blade cuts around each design. Upkeep is short: every evening clean the blade and bed and release the air, and once a week drain the water that collects in the air system.

DTF Station Arc 127 automatic film cutter, rear view with a roll of printed DTF film loaded

Setup & first print

Daily & weekly maintenance

Troubleshooting

Software & drivers

Techniques & settings

Manuals & downloads

Watch DTF Station's video: Arc 127 cutter setup

More videos

Arc 127: preparing the cutter for operation
Arc 127: daily maintenance
Arc 127: weekly maintenance
Print and cut a DTF roll with the Arc 127 and Prestige XL3

Embedded from the manufacturer's official channel.

About the DTF Station Arc 127 automatic cutter for DTF and UV DTF film

The Arc 127 cuts printed DTF and UV DTF film around the outline of each design, so transfers and stickers come off the machine ready to sell instead of being trimmed by hand. Your RIP prints small black registration marks beside the artwork. On the cutter, a camera reads those marks, a vacuum bed and an air-powered clamp hold the film flat, and the blade follows the cut path. It works from a roll, feeding itself forward section by section, or from single sheets.

Spec Arc 127
Max media width 27.5 in (70 cm)
Max cutting size 23.6 x 31.5 in
Cut types Full cut, half (kiss) cut, crease
Work modes Roll with camera, single sheet with camera, blind cut without camera
Size and weight 52 x 80 x 40 in, 485 lbs
Air Small compressor, gauge above 60 psi while running

What matters for upkeep: the blade is the only part that wears quickly, and the air system collects water. Compressed air leaves moisture behind, and water left in the lines makes the clamp work harder and can damage the air parts over time.

Maintenance schedule at a glance

When What to do
Every evening Power off, shut off the compressor and release the air. Clean the blade and holder with alcohol, vacuum the bed, empty the catch basket, cover the cutter
Every week Drain the water from the filter bowl inside the cutter and from the compressor tank
New film or new blade Run a blade test on scrap and set the blade pressure
Rough or incomplete cuts Clean the blade, retest, then replace the blade

Where to put it

Pick a spot it can stay in, on a level, solid floor, with at least 2 ft of working room on all four sides. Once it's in place, tighten the four foot stoppers. The user manual asks for a clean room at 68 to 82°F (20 to 28°C) with 40 to 60% humidity, away from direct sunlight, heaters, dust and damp. Give it its own power, not a circuit shared with a heat press or other heavy equipment. At 485 lbs it needs a forklift, lift straps or at least six people to move.