Support
Machine type
Brand
Epson SureColor F7200

Epson SureColor F7200 support

Covers: F7200

The SureColor F7200 is Epson's 64-inch roll-to-roll dye-sublimation printer. It runs four colors (High Density Black, cyan, magenta and yellow) from refillable ink tanks that you top up from 1-liter ink packs, swapping in the chip unit that comes with each pack. Keeping it printing comes down to weekly cap and print head cleaning, stirring the High Density Black ink once a week, and refilling ink the way Epson describes.

Epson SureColor F7200 64-inch dye-sublimation printer, front view

Setup & first print

Daily & weekly maintenance

Troubleshooting

Error messages

Techniques & settings

Manuals & downloads

Epson's video: F7200 cap cleaning maintenance

Embedded from the manufacturer's official channel.

About the Epson SureColor F7200

The F7200 prints dye-sublimation transfer paper up to 64 inches wide from rolls on 2 or 3 inch cores, and rolls the printed paper onto its auto take-up reel. Its print head has 360 nozzles in each of 2 rows for each of its 4 colors. Ink goes into four ink tanks on the right side. Each Epson ink pack comes with a chip unit that tells the printer how much ink was added, so you always refill one whole pack and swap that chip at the same time. You print from RIP software, and media settings are stored in the printer's control panel.

Epson's maintenance schedule at a glance

When What to do
Before printing Print a nozzle check and clean only the rows with gaps
Once a week Clean around the print head, clean the caps with the cap cleaning kit, and stir the High Density Black ink
Smudges or gaps return Clean the wiper. Replace the wiper and wiper cleaner together if they're worn
When the screen asks Replace the waste ink bottle, and refill ink with a new chip unit
When dirty Wipe the platen, pressure rollers and media holding plates

Where to put it

Epson rates the F7200 for 59 to 95 °F (59 to 77 °F recommended for consistent color) and 20 to 80% humidity (40 to 60% recommended), without condensation. Keep it out of the airflow of heaters, air conditioners and vents, which dry out the nozzles, and keep the room ventilated and free of dust. The printer weighs about 604 lb without ink, so plan its spot before it arrives. Turn it off with the power button, never by pulling the plug or switching off the breaker, so the head can return home and cap. If it will sit unused, Epson says to turn it on at least once every two weeks, and to contact your dealer for service maintenance before and after any longer break.