Support
Machine type
Brand
Phoenix Air 16x20 DTF Curing Oven

Phoenix Air 16x20 DTF Curing Oven support

Covers: Phoenix Air 16x20 · Seismo S20

The Phoenix Air 16x20 is a desktop DTF curing oven with bottom heating and a built-in purifier, for sheets up to 16 x 20 inches. DTF Station's manual suggests 140°C (284°F) for 60 seconds as a starting point. Preheat it about 10 minutes, keep the purifier off while it heats, and judge every cure by the glossy orange-peel finish.

DTF Station Phoenix Air 16x20 DTF curing oven with built-in purifier

Setup & first print

Daily & weekly maintenance

Troubleshooting

Techniques & settings

Warranty & service plans

Manuals & downloads

Watch DTF Station's video: printing, powdering and curing with the Phoenix Air oven

Embedded from the manufacturer's official channel.

About the Phoenix Air 16x20 DTF Curing Oven

The Phoenix Air 16x20 cures powdered DTF sheets on a heated bottom plate, with a purifier box on the lid that pulls fumes through a HEPA and carbon filter. You set temperature and time on the digital controller, press start, and it beeps when the time is up. Most shops pair it with the Seismo S20, a manual powder station for sheets up to 16 x 20 inches.

Spec Phoenix Air 16x20
Max film size 16 x 20 in (40 x 50 cm)
Power 1000 W, 110 V, 9 A
Temperature range Up to 150°C (300°F)

Maintenance at a glance

When What to do
Every session Preheat about 10 minutes with the purifier off. Turn the purifier on while a cure is running and off when you're done.
Monthly Replace the HEPA and charcoal filter (DTF Station's current advice; change sooner if smoke gets through)
When curing looks uneven Check the plate with an infrared thermometer at the center and corners

Where to put it

Run it on its own circuit, not with a heat press or other high-power equipment. If you must use an extension cord, the manual calls for one rated at least 16 A. Keep the room ventilated even with the purifier running.