Support
Machine type
Brand
Prestige X6

Seismo V36R maintenance: daily powder cleaning, oil drainage and filter changes

✓ Reviewed by Jason KimUpdated 1 min readFits: Seismo V36R
Short answer

At the end of each day, power off, clean powder out of the chamber, paddle, powder box and seal, tension bar, front heating plate and control panel, and empty the powder box completely. Open the front dryer for 1 hour so oil drains into the collection tray. Drain that tray weekly or when it fills, sift reused powder through a 60-mesh screen, and replace the smoke filter when extraction gets weak.

The V36R moves a lot of powder and a lot of heat. Most problems with uneven powder, clogging and oily prints trace back to cleaning that was skipped. This is DTF Station's routine, in the order that makes sense at the end of a shift.

Disconnect the external power supply before any cleaning or repair. Let the dryers cool before you reach inside.

End of every day

  1. Finish the roll safely

    Turn off all the heating switches when curing is complete. If the roll is nearly empty, use Manual mode to run the last film through.

  2. Shaker chamber

    Clean any leftover powder out of the inside of the chamber so it can't absorb moisture or contaminate the next run.

  3. Shaking paddle

    Clean powder off the paddle.

  4. Powder box and seal

    Clean the powder box and the rubber seal around it. Powder left on the seal absorbs moisture and can cause clogging or air leaks.

  5. Empty the powder box

    Empty the powder box completely. Use Powder Box Cleaning (hold 3 seconds, container underneath) to shake out what's left.

  6. Tension bar, front plate and panel

    Clean powder off the media tension bar and the front heating plate, and wipe powder off the control panel.

  7. Drain the oil

    Open the front dryer so the oil on the pipe walls and dryer runs into the oil collection tray. After 1 hour, close the front dryer.

Weekly or as needed

  1. Check the oil tray

    Look at the oil collection tray and empty it when needed, at least weekly in steady production.

  2. Remove and clean it

    Loosen the screws, take the tray out, empty it, wipe it clean with isopropyl alcohol and a lint-free wipe, and refit it.

  3. Control box

    Clean the control box and keep it dry.

Powder handling

  • Sift reused powder through a 60-mesh screen before it goes back in the box.
  • Store powder sealed and dry. See how to store hot-melt powder.
  • Keep the shaker cover closed while running. It keeps powder out of the belt area and lowers the noise.

Smoke filter

When smoke extraction gets noticeably weaker, replace the filter in your fume purifier. DTF Station recommends its own smoke filter. If you use another unit, its extraction rating must be between 36 and 202 m³/h.

If oil keeps dripping onto prints after cleaning, or the powder outlet stays blocked, Text us a photo or short video at (562) 609-4996.

Common questions

Why do I have to empty the powder box every day?

Powder left in the box absorbs moisture overnight, which can clog the powder outlet or cause motor failure.

Where does the oil come from?

Curing DTF releases an oily residue that collects on the dryer and pipe walls. Leaving the front dryer open for an hour at the end of the day lets it run into the oil collection tray.

How do I remove the oil tray?

Loosen its screws and slide the tray out, then empty and clean it and refit it.

Can I reuse powder?

Yes, but sift it through a 60-mesh screen first to remove contaminants, so it doesn't clog the powder brush or weaken adhesion.

Did this fix it?