Support
Machine type
Brand
DTF Station Aries 213 and Aries 113 UV DTF printers

Aries UV DTF white ink circulation not working: what to check first

✓ Reviewed by Jason KimUpdated 2 min readFits: Aries 113 · Aries 213 · Aries 124
Short answer

The Aries white ink circulation only runs when the carriage is docked over the capping station, so reset the carriage first, then switch circulation back on. Check that the power button is in and the dial is turned up (25 on the Aries 124), and that the white bottle has ink with its valve open. If it still won't run, a sensor, switch, knob, board or the pump has failed. Send us a video and we'll identify the part with you.

Why it matters

UV white ink settles fast. The circulation pump keeps it moving through the white line so the head gets evenly mixed ink. If the pump stops, white starts dropping out on the nozzle check and coverage turns patchy.

Checks you can do

  1. Dock the carriage

    Circulation only runs with the carriage parked in its home position over the capping station. Press Carriage Reset (or reset from the panel) so it docks, then switch circulation on again. This is the most common cause, and if it runs now you're done.

  2. Check the switch and setting

    Make sure the circulation power button is pressed in and the knob or dial is turned up. On the Aries 124, set the dial to 25 and press the power button. On the Aries 213, turn the knob clockwise, run it in manual mode for at least a minute, then switch it to auto.

  3. Check the white bottle

    Confirm there's white ink in the bottle and its valve at the back is open. Leave the bottle cap slightly loose so air can get in. Shake new white ink for a full 60 seconds and let it rest a few minutes before pouring.

  4. Remember the emergency stop

    When the Aries is left with the emergency stop pressed, it keeps circulation and stirring running. After you release it, check circulation is still on.

When it still won't run

If the carriage is docked, the button is on and the dial is up but nothing circulates, one of these has failed: the carriage home position sensor, the circulation power button, the control knob, the control board, its power supply, or the pump motor. Most of them show up as indicator lights on the control board inside the side panel, so we can usually tell which part it is by having you read those lights while we're on a video call with you. Please don't open panels or swap parts before talking to us. Several of these are wired to the board, and a wrong guess wastes a part.

When you contact us, have ready:

  • Your model (113, 213 or 124) and serial number
  • A short video showing the carriage docked, you pressing the circulation button and turning the knob
  • Your latest nozzle check

Keep printing short jobs only if the white nozzle check is still good. If white is dropping out, stop. Running with settled white can lead to clogs that are hard to recover.

Text us a photo or short video at (562) 609-4996.

Watch DTF Station's white ink circulation troubleshooting

Embedded from the manufacturer's official channel.

Common questions

Why did circulation stop after I moved the carriage?

It only runs with the carriage docked in its home position. Reset the carriage and switch circulation on again.

What should the circulation dial be set to on the Aries 124?

DTF Station's routine sets it to 25 and then presses the power button.

Does circulation keep running overnight?

When the Aries is left with the emergency stop pressed, circulation and stirring keep running. Check it's on after you release the stop.

Can I replace the pump myself?

Talk to us first. The same symptom can come from the home sensor, button, knob or board, and we can tell which one from the board lights on a video call.

Sources
Did this fix it?