Support
Machine type
Brand
DTF Station Prisma Dual Heat Press

Prisma Dual work modes, presets, press counter and temperature calibration

✓ Reviewed by Jason KimUpdated 2 min readFits: Prisma Dual
Short answer

Manual mode swings on SWING and presses only when you push both PRESS buttons. Semi-Auto swings and runs one press cycle by itself. Auto keeps swinging and pressing continuously after you start it, with a buffer time between cycles that DTF Station suggests setting to 5 to 10 seconds. If the platen doesn't reach the set temperature, run Start Calibrate in Advanced Settings.

The Prisma Dual's main screen shows temperature, time and pressure, the work mode, the press count, a status bar, the Duration setting and the Advanced Setting button. Everything below is set from that screen.

Pick a work mode

Mode What SWING does What the PRESS buttons do Use it for
Manual Moves the arm to the other station Both together lower the heat platen First shirts, new jobs, anything you want to watch
Semi-Auto Moves the arm and runs one press cycle by itself Not needed for each press Steady work where you load at your own pace
Auto Moves the arm to the other station Both together start continuous swing and press cycles Long runs of the same garment

Before you start Auto mode, tap Duration Setting and set the buffer time between cycles. DTF Station recommends 5 to 10 seconds. Then position the first garment and press both PRESS buttons.

In Auto mode the arm keeps moving on its own. Keep your hands out of the swing path and know where the RELEASE button is. Pressing it stops the cycle and the status bar shows Emergency On.

Single, double and triple press

Tap the Time icon or press SET and choose Single Press, Double Press or Triple Press. Each press in the cycle has its own time, so you can do a short pre-press, the main press, and a finishing press in one cycle.

Save presets

  1. Open Advanced Setting

    Tap Advanced Setting on the main screen.

  2. Pick a slot

    Choose one of the 10 preset profiles and use Name Setting to name it after the material.

  3. Store the settings

    Save the temperature, time and pressure for that job. Load it the next time you run that material.

Read the status bar

  • Standby: idle and ready.
  • Swing Left or Swing Right: the arm is moving.
  • Down, Pressing, Up: a press cycle is running.
  • Emergency On: the cycle was interrupted, for example by the RELEASE button.

Temperature not reaching the set point

  1. Measure first

    Let the press heat fully, then check the center of the heat platen with a contact surface probe. Write down the screen reading and the probe reading.

  2. Run calibration

    Tap Advanced Setting, then Start Calibrate. The button turns green while calibration runs on its own and goes back to red when it is done.

  3. Check again

    Measure the platen again after calibration.

Reset Settings in the same menu returns the press to factory defaults. DTF Station lists it as a troubleshooting step. Write down your presets before you use it in case they are cleared. If calibration doesn't fix the temperature, or the press won't swing or press, Text us a photo or short video at (562) 609-4996.

Common questions

What is the Duration setting?

It is the waiting time between press cycles in Auto mode, so you can swap garments. DTF Station recommends 5 to 10 seconds.

How do I make the press do two presses in a row?

Tap the Time icon or press SET, choose Double Press (or Triple Press) and set the time for each press.

How many presets can I save?

Up to 10, under Advanced Setting. Use Name Setting to rename one for a material, such as cotton, polyester or DTF film.

How do I zero the press counter?

Long-press Press Counting on the main screen, then tap Counting Reset.

Can I switch between Fahrenheit and Celsius?

Yes. Use the unit toggle in Advanced Setting.

Sources
Did this fix it?