Support
Machine type
Brand
Uninet iColor white toner transfer printers (560, 650, 800W and earlier models)

iColor AquaClear 1 Step paper for candles, glass and ceramic: printing and applying the water-slide transfer

✓ Reviewed by Jason KimUpdated 1 min readFits: iColor 500 · 550 · 600
Short answer

AquaClear 1 Step is a water-slide transfer, so there's no heat press. Print on the glossy side from the multipurpose tray with paper type Heavy, Letter size and no mirroring. Trim close to the image, dip it in water for about 30 seconds, rub the carrier off between your fingers, lay the image on the candle, glass or ceramic, smooth out the bubbles, blot off the water and let it dry for 3 hours.

What AquaClear is for

iColor AquaClear 1 Step is an all-in-one transparent transfer for hard surfaces: candles, ceramic, glass and more. You print it, soak it, and slide the image onto the item. Because it's applied with water instead of heat, it suits candles and anything else a heat press would damage. For pressed hard-surface transfers on mugs, metal and wood, see our iColor 1 Step Hard Surface paper guide instead.

Uninet's instruction sheet is written for iColor printers with a multipurpose tray. AA's listing for this paper names the iColor 500, 550 and 600. If you have a different iColor model, text us before you buy.

Print it

  1. Load the sheet glossy side up

    Put the transfer sheet in the printer's multipurpose tray with the glossy side up.

  2. Set the job

    Print from Multipurpose Tray, paper type Heavy, page size Letter. Don't turn on mirror printing.

  3. Print

    Print the image. If you're putting it on clear glass or a dark surface, Uninet suggests using the iColor transferRIP to add a white underprint so the colors show.

Apply it

  1. Trim close

    Cut the image out as closely as you can.

  2. Soak about 30 seconds

    Dip the cut-out in water for approximately 30 seconds. It will roll up. That's normal.

  3. Slide off the carrier

    Take it out of the water and rub the image gently between your thumb and pointer finger to slide off the carrier.

  4. Place and smooth

    Lay the image on the candle, glass or ceramic. Brush it with your finger or a piece of plastic to push out any air bubbles.

  5. Dry

    Remove the excess water and let it dry for 3 hours before handling.

When to use something else

  • Shirts and other fabric: use an iColor textile transfer paper, not AquaClear.
  • Mugs, metal, wood and other items that can take heat: Uninet's 1 Step Hard Surface papers are pressed on instead.
  • Not sure which paper fits your job? Uninet's hard surface sample media kit lets you try several before you buy a full pack.

Image won't release from the carrier, or colors look weak on a dark candle? Text a photo to (562) 609-4996 and tell us which iColor model you're printing on.

Watch Uninet's video: using iColor AquaClear 1 Step transfer paper

Embedded from the manufacturer's official channel.

Common questions

Do I need a heat press for AquaClear?

No. It's applied with water, which is why it's used on candles and other items that can't take heat.

Should I mirror the image?

No. Uninet's instructions say do not set the job to mirror print.

The paper curled up in the water. Is that wrong?

No. Uninet says it rolls up during the 30 second soak, and that's normal.

Can I print white under the image for clear glass or dark surfaces?

Uninet says to combine it with the iColor transferRIP to add a white underprint for clear and dark surfaces.

How long before I can handle the piece?

Remove the excess water and let it dry for 3 hours.

Did this fix it?